Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!
Search filter:
Clear Filter
Your search term must have 3 or more characters.
OLDER Ice Maker on the fritz
6 of 14 peoplefound this instruction helpful.
Eric S from Boca Raton, FL
Really Easy
15 - 30 mins
Nutdriver, Wrench set
Grat help on the phone. We saw repair on YouTube. my wife and I worked it together. It was child's play!! It went beautifully. we were able to "chill out" with ice aplenty!!Thanks...eric
Was this helpful?
Thank you for voting!
Plastic broke internally would allow the door to close.
2 of 2 peoplefound this instruction helpful.
Steven from DANVERS, MA
Very Easy
Less than 15 mins
Screw drivers
That 1 Phillips screw out push up disconnect electrical plug put new one in by going in the opposite way.
Was this helpful?
Thank you for voting!
No Problem This was a simple replacement of the water filter.
2 of 2 peoplefound this instruction helpful.
Charles L from ROSEVILLE, CA
Really Easy
Less than 15 mins
Lower the filter cover on the refrigerator, twist the old filter to remove it, install the new filter by pushing and twisting it, and close the filter door. Using a pitcher, run water through the new filter until the excess carbon leavings are out then the water is clear and is drinkable
Was this helpful?
Thank you for voting!
Not making enough ice
2 of 2 peoplefound this instruction helpful.
Regina from CLINTON, AR
Really Easy
Less than 15 mins
Just open the filter and put it in the slot
Was this helpful?
Thank you for voting!
Light didnt go on
3 of 5 peoplefound this instruction helpful.
dorotea from staten island, NY
Really Easy
Less than 15 mins
Screw drivers
The light rocker switch wasnt working. I found the part on the web site. It was so easy. I used a screw driver to pop out the old one and pop the new one in. It took 5 min. Thanks!!!
Was this helpful?
Thank you for voting!
fridge door switch did not work
2 of 2 peoplefound this instruction helpful.
stu from richmond, VA
Easy
Less than 15 mins
Socket set
I removed the switch housing (4 screws), replacing the switch in the housing was a snap. It took 5 minutes, cost $8 and light works like new!
Why didn't I order this part and do the repair earlier? Very simple.
Was this helpful?
Thank you for voting!
Door light switch disintegrated
2 of 2 peoplefound this instruction helpful.
Thomas from Roseville, CA
Really Easy
Less than 15 mins
Screw drivers
Very simple fix, remove 3 screws, two connectors to the old switch
Was this helpful?
Thank you for voting!
ice maker
2 of 2 peoplefound this instruction helpful.
Ann from MC CUNE, KS
Really Easy
30 - 60 mins
My husband is an appliance man and he did the work.
Was this helpful?
Thank you for voting!
10 years old, bifold top doors, right side seal torn, causing the refridge to not seal and lose cooling capability from leakage
2 of 2 peoplefound this instruction helpful.
susan from herndon, VA
Difficult
More than 2 hours
Socket set
WITH PATIENCE! removal of door and old seal no problem! Followed the video- very clear. The part was difficult. Ornery plastic that needed to be softened and clipped (in comes the hairdryer and vaseline)- First corner great! the other 3 -patience. we set the door on a folding table with a towel on top to prevent scratches and ability to
... Read moreslide it around . inserting the dense plastic flange to clip under the seal was the most difficult . i approached the insertion from the opposite side so I was PULLING the seal into place with the base of a putty knife.( instead of my pushing fingers-70 arthritic- use tools to help!! It took bit longer, a challenge- can be done, I am so happy i don't have to look for a new refrigerator!!!! Thank you for that instructional video which gave me the courage for the repair.
Changed water filter. Water came out slowly. took off filter and reinstalled water came out good stream. Ice maker is still not working.
3 of 5 peoplefound this instruction helpful.
Orville from Albuquerque, NM
Difficult
30 - 60 mins
Just stood in front of the refrigerator and disconnected the water filter and replaced it with the new one I purchased from by hand
Was this helpful?
Thank you for voting!
ordered a new ice maker, new refrigerator did not come with one.
2 of 2 peoplefound this instruction helpful.
Scott from ROCHESTER, NY
Easy
30 - 60 mins
Nutdriver, Screw drivers, Wrench (Adjustable)
I watched the video that was included with my on line order, it was helpful, although different model shown . I would say it was not difficult to install, the enclosed instructions were a bit confusing.
Was this helpful?
Thank you for voting!
freezer (later fridge too) wouldn't stay cold~
2 of 3 peoplefound this instruction helpful.
David from MARYLAND HTS, MO
Very Easy
30 - 60 mins
Nutdriver
****Make are you order Capacitor & Starter relay too (we ordered separtely so had to pay shipping twice)**** Super easy just open access panel on back near compressor and remove retention clip with fingers, remove & replace both capacitor & starter, put clip and acce
... Read moress panel back on, plug in and allow 8 hours to cool! Works like new again! Hope it goes another 10 years
The door switch was broken so the interior light would not come on.
2 of 3 peoplefound this instruction helpful.
Catherine from BROOMALL, PA
Easy
Less than 15 mins
Screw drivers
The instructions in the package were not helpful. They wanted me to cut the wiring harness and described where to cut based on the wire colors. My wires were not the same color! I removed the light mechanism using a combination of a screwdriver, putty knife, and plain old muscle with my fingers! The wiring harness unplugged easily and th
... Read moree new one inserted. It was easy to push the whole assembly back into the door. I spent more time looking for something to cut the wiring harness with (and never did find it) than the whole job actually took without needing to cut anything!
My Orders
