WMCD2050H2WC General Electric Washer - Parts

This screw is sold individually.

This screw is sold individually.

This part helps center and support the drum, transmission and motor assembly.

This is a replacement screw for your washer. The screw has a hex head and is approximately 1 inch in length. The washer portion of this screw is approximately 1 inch in diameter. This part is sold individually and is an authentic OEM part sourced directly from the manufacturer.

The triple water valve or inlet valve in your washer connects to the water source and solenoid wires, and ensures the tub has the right amount of water entering it. If your washing machine continues to fill after it is full, or if it fills slowly, you may need to replace this valve. Before you begin this repair, be sure to disconnect the water and power sources from your washer. This part is sold individually.

This part is the replacement belt install tool for your dryer. It comes with two round plastic halves of the tool that are held together with an o-ring (also included). To use the tool, position the two halves of the tool together, and roll the o-ring into the groove to secure. The belt install tool will allow you to replace a damaged dri...Read moreve belt on your dryer. Be sure to disconnect power to the dryer before you begin this repair. This is an OEM part sourced directly from the manufacturer.

This shaft and mode shifter assembly is designed for select washing machine models and plays a critical role in transitioning between the wash and spin cycles. Sometimes referred to as the gearcase or transmission, it connects the motor to the wash plate and responds to commands from the washer’s control system to shift the drive mechanis...Read morem accordingly. A faulty assembly may result in improper agitation or spinning, cycles that end prematurely, or grinding noises during transitions. Replacing this part can restore smooth operation and cycle performance.

Sold individually.

Sold individually.

This cover goes on top of the balance ring that is located on top of the basket.

This is a water hose clamp kit for a variety of appliances including dishwashers and washers. This is a genuine replacement part. The kit includes two hose clamps. The smaller of the two is 1 inch in diameter while the larger one is 2 inches in diameter. The hose clamps secure the end of the water hose in place to prevent the hose from le...Read moreaking. If you notice leaking from the hose of your appliance, you may need to replace this kit. Protect your hands with work gloves during this repair to avoid injury.