WL600607 Campbell Hausfeld Compressor - Parts

The shoulder bolt attaches to the rubber bushing and the roll bar. This item is sold individually and is made of metal. This part is an OEM from Campbell Hausfeld and Husky for use in air compressors. When replacing this bolt a wrench will be needed. It may become broken or stripped and will need to be replaced.

This is a manufacturer sourced replacement part designed for use with Campbell Hausfeld air compressors. The pressure switch tells your compressor when to stop and when to start. There are multiple reasons a pressure switch could be leaking air. If it is leaking air the pressure switch should be replaced for a compressor to operate proper...Read morely and safely. To complete this repair you would need: wrench set, nut driver set and a thread-sealing tape. • Shut off the electricity and drain the air tank • Remove the tank pressure gauge • Remove the pressure switch tube • Remove the pressure regulator assembly • Disconnect the wires • Remove the safety valve • Install the new pressure switch • Reinstall the safety valve • Connect the wires • Reinstall the pressure switch tube • Screw the pressure gauge onto the new pressure switch and tighten the gauge firmly • Test the air compressor

This is an authentic OEM sourced part which is specially designed for Campbell Hausfeld air compressors. It is an identical replacement for a missing or damaged exhaust tube that was installed on a new unit, please make sure to refer to the appropriate diagrams of your model for the correct location and application of this part. Keep in mind this high-quality tube is made of durable metal and is sold individually.

This is an OEM part made for use on Campbell Hausfeld air compressors. This rubber foot attaches to the bottom of the tank. It does not need special tools to repair. Simply slide onto the tank's bar. It stabilizes positioning of the compressor while protecting surfaces below. Sold individually.