My Orders
- Home
- WGC1586NXWW0
- Instructions
WGC1586NXWW0 General Electric Washer - Instructions
Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!
Search filter:
Clear Filter
Your search term must have 3 or more characters.
The washer stop and blinks in the RINSE MODE
58 of 63 people
found this instruction helpful.
-
Miguel from Jacksonville, FL
- Really Easy
- 30 - 60 mins
-
Nutdriver, Pliers
I called a repair person to check my 15 months old GE front loader washer that stopped in rinse mode. After his inspection he said it was a deffected computer board and it would be very expensive to replace the 3 computers boards inside and it would be cheaper to buy a new top loader washer. The next day I lifted the top cover and foun
... Read more
d a taped plastic envelope with instructions titled “For service Technicians Only." On page 2, instruction on to how to enter the washer in to service mode and to test the washer:
Press : Signal, Delay, Signal, Delay (within 30 seconds of plug in washer)
Then rotate main knob to #102 and press Start:(the washer did a test for finding the problem) , and for me was : E22 , it means : replace solenoid valve assembly.
So I order the part from Partselect.com for $58.00 and my Washer runs beautiful, thanks to the instructions inside.
Press : Signal, Delay, Signal, Delay (within 30 seconds of plug in washer)
Then rotate main knob to #102 and press Start:(the washer did a test for finding the problem) , and for me was : E22 , it means : replace solenoid valve assembly.
So I order the part from Partselect.com for $58.00 and my Washer runs beautiful, thanks to the instructions inside.
Read less
Was this helpful?
Thank you for voting!
stops at rise
12 of 24 people
found this instruction helpful.
-
Felipe from Houston, TX
- Easy
- 15 - 30 mins
-
Screw drivers
removed 5 screws, unscrew two more screws, remove the houses and disconnect the wires remove the watter valve.
Was this helpful?
Thank you for voting!
washer would stop at certain points in cycle
3 of 4 people
found this instruction helpful.
-
christopher from MINNEAPOLIS, MN
- Really Easy
- 15 - 30 mins
-
Pliers, Screw drivers, Wrench (Adjustable)
Replace the water valve according to the youtube video from this site. It was really easy!
Was this helpful?
Thank you for voting!
Washer keeps Pausing.
0 of 1 people
found this instruction helpful.
-
Keith from Los Angeles, CA
- Really Easy
- 15 - 30 mins
-
Screw drivers, Wrench (Adjustable)
After getting error message from washer, Looked it up and found if the water lines are find, then replace the water valve. After replacing the valve, everything works fine.
Was this helpful?
Thank you for voting!