WFMC8400TC (14) Bosch Washer - Parts

This valve is used in washers and it is known as the washer inlet valve. This specific valve is used to control the flow of cold water into your washing machine. If your washer is leaking, if it will not fill, if it is taking a long time to fill, or if it will only operate with hot water the dual inlet valve made be restricted or damaged....Read more If you find this valve is damaged or restricted it will need to be replaced. Before you replace this part, or any other part on your washer, make sure the water supply has been shutoff and ensure the appliance is unplugged.

This drain pump, also referred to as a drain pump motor assembly, is designed for use with front load washers. This pump is used to remove the water from your washing machine during the washing cycle. When the spin speed of the tub is maintained for a specific period of time the drain pump is then activated. If your washing machine will n...Read moreot drain you may have an issue with the drain pump, it may be damaged, clogged, or faulty. If you find an issue with your drain pump you will need to replace it. This drain pump assembly includes the drain pump motor, impeller, pump housing, and pump filter.

This valve is designed for use with washers. Inlet valves on washers are what control the flow of water into your appliance, this valve is used to control the flow of hot water into your washer. If your washer is leaking, if it is only washing in cold water, if it is not filling at all, or if it is filling slowly you will need to check th...Read moree inlet valves. If you find this inlet valve is clogged, restricted, or damaged in any way you will need to replace it. Before starting repair work you need to shut off the water supply, this helps prevent any flooding or mess while replacing the valve in your washer.

Sold individually.

This door boot is for washers. Door boot forms a seal between the wash tub and the door, preventing leaks.

Front-loading washing machines use a suspension system to support the tub during the wash cycle. This suspension system is only designed to handle a certain amount of movement, so when you are transporting or moving the machine you will need shipping bolts to hold the tub in place. Using shipping bolts will help you limit any potential da...Read moremage that can be done to the suspension system during transport. This shipping bolt is comprised of three pieces, the bolt, the washer and the sleeve. You will need four of these bolts to hold the tub of your front load washer in place for moving.

Shock absorbers keep the washer from vigorous shaking during it's cycles. They are sold individually.

This drive belt is for washers. Drive belt connects the drive motor to the drive system in the washer to spin the basket.