WF316LAS (XAX) Samsung Washer - Parts

This is a 120 volt, 60 hertz drain pump assembly for a washing machine. It is a genuine OEM part. This pump helps expel water from the washing machine, and is activated after the spin speed is maintained for a specific period of time during the spin cycle. You may need to replace the pump assembly if your washer is not draining properly; ...Read moreit could be clogged or damaged. Be sure to disconnect the water supply and power to your appliance before repairing. This part is located at the rear of the washer behind the back panel.

This part is used for the shaft on the rear of the tub and is sold individually. The head bolt is part of the spider arm assembly, and they are generally changed at the same time. If you are replacing the entire spider arm assembly, make sure you order as many hex bolts as you will need. The spider arm assembly contains 6 of these hex bol...Read morets. The hex bolt or spider arm assembly may need to be replaced if you notice that your inner tub is going out of balance. The hex bolt measures 1.5 by 0.5 inches.

This is a door switch assembly designed for Samsung washing machines. This door switch assembly is used to latch and lock the door shut before the washing cycle commences and communicates with the control board when that is done. If your washer door is not locking or latching properly, the door switch is likely bad or broken and will need...Read more to be replaced. To replace this assembly, you will need a flat-head and Philips-head screwdriver. This part is a genuine OEM switch assembly and is sold individually, without any wire harnesses or securing screws.

One solenoid valve for hot water

Assembly BOLT;SWF-P12,MOTOR/

This manufacturer-approved screw is for refrigerators, including Kenmore refrigerator model. Avoid cross-threading refrigerator screw during installation.

This is a seal for various models of Samsung washing machines. This part acts as a seal for the rear and front outer part of your washing machine tub and is used to prevent any matter of leaks. If your washing machine is leaking or you notice water outside of the tub after a cycle is finished, this seal could be worn out or damaged and ne...Read moreed immediate replacement. This seal will be located between the two halves of the inner tub and replacing it will require you to disassemble your washing machine, and only requires a few parts like a screwdriver, wrench, and pliers. This OEM seal does not come with any other parts and is sold individually.

Three solenoid valve for cold water

This door boot (part number DC64-00802A) is for washers. Door boot DC64-00802A forms a seal between the wash tub and the door, preventing leaks. Unplug the washer before installing this part. Wear work gloves to protect your hands.

This is a door lever strike for Samsung washing machines. This part is used to latch and hold the washer door to the washer door frame when it is closed. If the door strike for your washer is currently broken, damaged, or not properly catching, this must be replaced for your door to close securely. This door strike is a genuine OEM part m...Read moreade of plastic and is sold individually, meaning it will need to be installed with the 2 screws securing the current door strike.