W14EN1 Magic Chef Washer - Parts

This screw is sold individually.

This hose clamp is used in a wide variety of household appliances. Most often it is found in washers, dishwashers, refrigerators, freezers, dehumidifiers, garbage disposals, or air conditioners. This clamp is used to securely attach a hose to another part of your appliance, which helps prevent leaks from those connections. Depending on th...Read moree appliance, it can attach hoses to drain pumps, water inlet valves, pressure switches, and injector nozzles. We recommend you refer to model-specific diagrams for appropriate uses and exact placement. This hose clamp is made of metal, and is sold individually. To access and replace this part you will need a nut driver, pliers, and screwdrivers. Before you begin any repair work, make sure you have unplugged your appliance, and shut off the water supply if applicable.

Sold individually.

This screw is sold individually.

This screw is sold individually.

The hose clamp is used to hold the water hose in place which will prevent the hose from leaking water. Sometimes the clamp may lose its ability to latch on, causing a leaking washer. For the installation, you will need a flat head screw driver to replace the clamp and a drill to access the screws to remove the front of the washer. Be care...Read moreful if you do not have specific clamp pliers as the clamp could fly off. Once the front of the washer has been removed, take a quick look for water damage or any obvious signs of where the leak is coming from. If it is not obvious, run water to test.

This is part of the lid switch actuator mechanism and activates the lid switch, when the lid is closed, to start the wash cycle and when the lid is open, it stops the cycle.

This hose can handle hot or cold water and is five feet long.

This screw is sold individually.

The lid switch kit is an assembly for replacing your washer lid switch. The function of this part is to detect if your washer lid is open or closed. If it detects that it is open it will prevent the washer from rotating and agitating until it is closed. This kit includes the bracket, actuator, switch, screws, and wire harness. To complete...Read more this installation, you will need a number two Phillips screwdriver, and a 5/16 nut driver. Before beginning this repair, make sure the power supply to your washer is disconnected. In order to install this part, you will need access to the rear of the unit.

This clamp is sold individually.

Sold individually.