VT629900 Campbell Hausfeld Compressor - Parts

This is an authentic Campbell Hausfeld replacement part that has been sourced from the original manufacturer to be used with air compressors. The metal cap assembly is used to support the crankshaft bearing to keep the shaft in position on the wall of the crankcase. This item is available as an individual replacement part.

This is a manufacturer sourced replacement part designed for use with Campbell Hausfeld air compressors. The pressure switch tells your compressor when to stop and when to start. There are multiple reasons a pressure switch could be leaking air. If it is leaking air the pressure switch should be replaced for a compressor to operate proper...Read morely and safely. To complete this repair you would need: wrench set, nut driver set and a thread-sealing tape. • Shut off the electricity and drain the air tank • Remove the tank pressure gauge • Remove the pressure switch tube • Remove the pressure regulator assembly • Disconnect the wires • Remove the safety valve • Install the new pressure switch • Reinstall the safety valve • Connect the wires • Reinstall the pressure switch tube • Screw the pressure gauge onto the new pressure switch and tighten the gauge firmly • Test the air compressor

It is a genuine replacement part that is supplied directly from the original equipment manufacturer, it is specially designed for use with Campbell Hausfeld air compressors. For the correct location and use of this hardware make sure to check appropriate diagrams of your model. Please note this high-quality screw is sold individually.

This is an authentic Campbell Hausfeld replacement part, sourced from the original manufacturer for use with air compressors. The special set screw is commonly used to secure the pump's flywheel. This set screw is available as an individual replacement part, please see model diagram for associative parts.

It is a genuine item that is supplied by the original equipment manufacturer for use with Campbell Hausfeld air compressors. This is an updated wire belt guard to replace the older plastic guard, keep in mind it includes the front and the back pieces. Please make sure to refer to the appropriate diagrams of your model for the correct loca...Read moretion and application of this component. This high-quality item is made of durable metal and is sold individually.