VT558703 Campbell Hausfeld Compressor - Parts

Designed for use in compressors, this genuine replacement part is used to provide a seal and prevent leaks. It is red, made of rubber, is not part of a kit or assembly, and is sold individually. When this part is worn, you will notice leaks from your machine, and it will need to be replaced. As with most rubber seals, this part is known...Read more to wear with regular use of your compressor, and will no longer be able to properly seal when it needs to be replaced. It is found at the bottom of the air tank, and you will need a wrench to complete this repair. Customers rate this repair as Easy.

Genuine Campbell Hausfeld replacement part, this item is sold individually. The ST033001AV Compression Nut is used to attach the copper tubing to certain components of the compressors listed below. Along with the Compression Nut you will need to use a compression sleeve ( or Ferrule) to seal the tube from leaking air. The Compression Nut will go on the tubing first then the Ferrule will slide into the nut.

This ASME safety valve is constructed of high-qualty metal, and is made for use with many air compressor models. Fastened to the manifold, the safety valve diminishes air pressure when the pump is not shut off at the proper setting. This important component is sold individually. A screwdriver, adjustable wrench and a pair of pliers are of...Read moreten necessary for the removal and replacement. Please refer to the specific manual for additional repair information.

This is a genuine Campbell Hausfeld replacement drain valve, sold individually. When using an air compressor, moisture naturally condenses inside the tank. If this water is left sitting for too long, it can lead to internal rust and damage. The drain valve allows you to release this built-up moisture easily. It's especially important to d...Read morerain your tank after each use—particularly if you tend to leave air in the tank for extended periods. Regular draining helps extend the life of your compressor and maintain its performance. Be sure to open the valve regularly to prevent water buildup and potential tank corrosion.

Svc Compressor Pump Cw 75 X 51Mm

This authentic replacement part is designed for Campbell Hausfeld air compressors. It is sourced directly from original equipment manufacturer and it is sold individually. The pressure is build in such a way that it will let your compressor know when to stop and when to start building up pressure. There are different reasons a pressure sw...Read moreitch could be leaking air, however if it is the pressure switch should be replaced immediately. To complete this repair you will need: a wrench set, a nut driver set and a thread-sealing tape.

This is an authentic Campbell Hausfeld replacement part, sourced from the original manufacturer for use with air compressors. The special set screw is commonly used to secure the pump's flywheel. This set screw is available as an individual replacement part, please see model diagram for associative parts.

This motor is for air compressors. The motor spins the compressor pump shaft drive components to pressurize the air in the tank. Release the pressure from the air tank before servicing. Wear work gloves to protect your hands.

This replacement pressure gauge is specially produced for Campbell Hausfeld air compressors. It is a genuine item that is supplied directly from original equipment manufacturer. The gauge registers pressure readings for the user. Please note, this metal body gauge is sold individually. You should only need a wrench to complete this repair. The dial reads 0-300 PSI.