Models > UT80522A > Instructions

UT80522A Homelite Pressure Washer - Instructions

All Instructions for the UT80522A

Fuel system damaged by allowing E85 gas to remain in tank.

Tank is held in place by 2 nuts and 1 bolt. These were removed and tank lifts off. Installed filter assembly and fuel hose to bottom of new fuel tank. You must install fuel hose clamp to tank connection before installing new tank. Install the other end of fuel line to carburetor on engine with other clamp and you are finished.

Parts Used:

Fuel Tube

Fuel Tank Outlet Assembly

Fuel Tank Cover

Fuel Tank

Jimmy from BURLINGTON, NC
Difficulty Level:
Easy
Total Repair Time:
30 - 60 mins
Tools:
Pliers, Socket set, Wrench set

3 of 4 people found this instruction helpful.

Was this instruction helpful to you?

Thank you for voting!

Must have froze over winter (stored in garage)

Repair was easy, however had to u tube issue for proper orientation of parts as it did not come with any instructions. Wished I had two as shipping was twice as much as part. Very satisfied.

Parts Used:

Detergent Suction Kit

Duarte from GRISWOLD, CT
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins
Tools:
Wrench (Adjustable)

5 of 12 people found this instruction helpful.

Was this instruction helpful to you?

Thank you for voting!

Leaking hoses.

1) Loosen engine assembly from frame.
2) Remove fuel tank, hoses and disassemble other hoses and components.
3) Attach new hoses to carburetor.
4) Reassemble fuel tank, engine and carburetor components.
5) Re-center motor engine assembly onto washer frame and tighten nuts, bolts and washers as needed.

Parts Used: