UT20747 (Trim N' Edge) Homelite Trimmer - Parts

Genuine Homelite replacement part, this item is sold individually. This tube is installed inside the fuel tank on the outdoor products listed below. The fuel filter is attached to one end of this tube. It is then attached to the inline fuel fitting on the outside of the fuel tank. Then the fuel line going to the carburetor is attached to the other side fuel fitting .

This is an authentic Homelite replacement part, sourced from the original manufacturer for use with outdoor power equipment. The special rubber tubing is used to carry fuel that powers the tool's engine. This length of tubing is available as an individual replacement part, please note the tubing will need to be cut to fit. Approximate length • 10' (3048 mm)

This is a genuine replacement part sourced directly from the manufacturer. The starter grip is commonly found in Homelite blowers and trimmers. This part is made of high-quality plastic, and it attached to the end of the rope in the starter assembly to provide the user with a secure grip for pulling. This item is sold as an individual replacement part.

This is an authentic Homelite replacement part that has been sourced from the original manufacturer for use with trimmers and chainsaws. The screw is used with different types of machines and the application of the screw can vary based on the model of equipment. This item is available as an individual replacement part.

This is an authentic replacement part sourced directly from the manufacturer. The electrical lead is commonly found in Homelite trimmers and blowers. This part is a metal electrical cable with a flexible plastic casing. It is used to connect the ignition module with the spark plug. You may require an Allen wrench or screwdriver when replacing this part. This is an individually sold item.

This genuine manufacturer-sourced replacement part is specially supplied for use with Homelite and Ryobi handheld lawn and garden equipment. A lock nut is a type of nut that resists loosening when properly threaded onto a bolt, for correct application please refer to appropriate diagrams of your model. This high-quality lock nut is made of durable metal and it is sold individually.

This is an authentic replacement part that has been sourced from the original manufacturer to be used with trimmers, pruners and blowers from Ryobi and Homelite. This pan head screw is commonly used to fasten the ignition module to the cylinder assembly. The screw is available as an individual replacement part, please note two screws may be required.