UT20004B (TrimLite) Homelite Trimmer - Parts

This item has been OEM sourced and is intended to be used with gas-powered trimmers and pruners from Ryobi & Homelite. The gasket is used to seal the connection between the cylinder and the crankcase. It is recommended to replace gaskets when servicing the motor to ensure proper seals and spacing when the parts are reassembled. This item is priced as a single part.

This is a genuine OEM replacement part, it is sold individually. The Housing and Eyelet contain the spring and the spool and string for the models listed below. The cutting string is inserted through the eyelets, then the spool is inserted into the housing, it is then attached by the spool retainer.

This is a genuine OEM replacement part, it is sold individually. The purpose of this part is to connect the fuel line extending from the fuel tank to the fuel line that connects to the carburetor. Over time the fuel lines will become brittle and oversized. They will have to be replaced. This would be a good time to replace the Fuel Fitting also.

This is a genuine OEM sourced replacement starter rope, not an aftermarket equivalent. This part is used to pull start Homelite and Ryobi handheld lawn and garden equipment. This rope is made from durable fabric and it is sold individually. Please note, the grip handle is sold separately. Replacing this starter rope you will need a screwdriver.

This item has been OEM sourced to ensure a high-quality standard. The rotor is intended to be used with trimmers, blowers, and chainsaws from Homelite and Ryobi. The rotor is the engine's flywheel and is used as one of the main components in the ignition sequence. The rotor has magnets on its edge that create an electric charge as they pa...Read moress the ignition module, this ignites the air/fuel mixture in the cylinder which rotates the crankshaft and the drive shaft. This item includes the pawls that make contact with the recoil starter pulley when the starter rope is pulled.

It is a genuine item that is supplied directly from the original equipment manufacturer for use with Homelite and Ryobi handheld lawn and garden equipment. This is the special screw which is utilized to secure the gear head, please refer to the appropriate diagrams of your model for the correct location and application of this hardware. K...Read moreeep in mind this durable metal hex head screw is sold individually, you will need a wrench to secure or remove it.

The curved shaft is a Homelite replacement part directly sourced from the manufacturer for use in trimmers. A screwdriver and a wrench set might be needed during the installation process. Over time this part may bend or break and will need to be replaced. It is made out of metal and is sold individually.

Ergo grip starter handle

This authentic item is supplied directly from the original equipment manufacturer for use with Ryobi, Homelite and Ridgid handheld lawn and garden equipment. It is an identical replacement for a missing or a damaged bumper that was installed on a new unit. The part helps to secure the fuel tank in the housing. Make sure to check the appro...Read morepriate diagrams for your model for the exact location and the correct application of this component. Keep in mind this high-quality bumper is made of durable material and is sold individually.

This is a high quality OEM sourced replacement part that is utilized with Homelite and Ryobi string trimmers. It is the intake gasket that helps to create an air-tight seal, please make sure to check appropriate diagrams for correct location and use of this item. Over time gaskets tend to deteriorate and crack eventually requiring replacement.