UT10782 Homelite Chainsaw - Parts

Keep in mind that this item and is priced individually. The guide bar adjusting screw is made out of metal. During replacement, it will require a phillips screwdriver to install this part correctly. Over time this item may strip or break and will need to be replaced. It is a genuine OEM sourced part which is specially designed for use with Homelite pruners, saws, and trimmers.

The hex nut attaches to the drive case cover. This part is made of metal and is sold individually even though many nuts may be needed during installation. This part may become stripped or lost and will need to be replaced. A wrench will be needed when replacing this part. It is an authentic OEM sourced item which is specially designed for use with Homelite and Ryobi chainsaws.

This replacement switch is an authentic item that is supplied directly from original equipment manufacturer for use with Homelite and Ryobi equipment. It is the key component of the tool handling on/off operations. Over time either mechanical or electric components of the switch may begin to fail eventually requiring replacement. Please note this high quality plastic body switch is sold individually.

This is a manufacturer approved replacement guide bar designed for Homelite chainsaws. The purpose of a bar is to hold the cutting chain. Having a bent or damaged bar is extremely dangerous and it should be replaced immediately. Guide bar is made out of metal and it is sold individually. Designed to accommodate for a 16" chain only. You...Read more would need a screwdriver a wrench set to replace this part. • Remove the housing • Release the chain tension • Remove the chain and the tensioner • Remove the bar and replace it with a new one • Secure the tensioner and the chain • Reassemble the housing and tighten the chain

This is a genuine part from original manufacturer, compatible with many Ryobi and Homelite chainsaws. An E-ring is a circular metal piece, notched with one open side. They are designed to clip into place on a shaft in order to keep other parts secured. Sold individually.

This part is an OEM from Ryobi and Homelite for use in chainsaws. The needle bearing fits between the sprocket drum and the cupped washer and helps to reduce friction. Over time it can wear out and will need to be replaced. A set of pliers, a screwdriver, and a socket set may all be needed to help replace this part. The bearing is made of metal and sold individually.

This slotted pan head screw is a genuine OEM item that is specially designed for use with Homelite and Ryobi chainsaws. It is generally used to secure the top cover which is sold separately. Please note, one metal screw is included per order. You will need a torx screwdriver to complete this repair.

The bronze element filter attaches to the duckbill valve. It is available as an individual replacement part. This item is an OEM from Homelite and Ryobi for use in saws. A set of pliers might be needed during the installation process. It will require replacing if it breaks.

This is a genuine OEM sourced replacement part designed for use with Homelite and Ryobi chainsaws. The ignition module also known as armature-magneto provides current for the ignition system by producing pulses of high voltage for the spark plugs. While there are various reasons for ignition module failure, the primary symptoms usually ma...Read morenifest in the form of extreme difficulty starting your equipment, and eventually, a no-start condition. It is a complete kit which includes a metal ignition module, rubberized lead wire, spark plug and two screws to secure it.

This is a genuine OEM supplied part that is specially made for use with Homelite chainsaws. The tubing is what delivers the oil from the tank, unfortunately, over time it will wear out and it may begin to crack eventually requiring a replacement. Please make sure to check the diagrams of your model for the correct location and application...Read more of this component. Keep in mind this high-quality tubing is made of durable rubber and is sold individually.