UT10582 Homelite Chainsaw - Parts

This metal OEM wire clamp is a type of fastener that holds hoses or cables together and keeps them from moving while your machine is operating. It is mostly found in lawn equipment to attach its fuel line to the filter. You can tell that the metal clamp is broken if the parts it was securing has become loose or has fallen off. When this h...Read moreappens, your equipment may start leaking and can pose as a safety hazard. To remove the wire clamp, you need a pair of pliers. Grip onto a broken clamp before twisting it counterclockwise to release it from your machine. This item is sold separately.

This is an authentic replacement part manufactured for use with Homelite chainsaws. The front hand guard is used to protect the user from the chain in case of accidental kickback. This front hand guard is available as an individual replacement part, please see model diagram for associative parts.

Authentic replacement part sourced from original equipment manufacturer. It is designed for use with Homelite gas chainsaws.Carburetor mixes the air and gas before the fuel mix is moved to the engine. This carburetor has a metal and it is sold individually. Please note gaskets are sold separately. If the engine won't start and the tank i...Read mores full of fresh fuel, test the carburetor by removing the air filter and pouring about a teaspoon of fuel into the carburetor. Pull the starter rope. If the engine starts and then quickly dies, the carburetor is likely the problem. To complete this repair you would need a screwdriver. • Remove the rear cover • Remove the carburetor • Remove the fuel filter • Install the fuel filter • Install the carburetor • Re-assemble and test the unit

It is an authentic Homelite ignition module also known as an armature-magneto is specially designed for use with chainsaws. The purpose of this part is to produce the pulses of high voltage for the spark plugs. It is made out of metal with a rubberized wire and the spark plug boot. To complete this repair you will need a screwdriver set.

This is a genuine part from original manufacturer, compatible with many Ryobi and Homelite chainsaws. An E-ring is a circular metal piece, notched with one open side. They are designed to clip into place on a shaft in order to keep other parts secured. Sold individually.

(T20, M4 Torx)

This is an OEM replacement part manufactured for use with Homelite chainsaws. This plastic fuel tank assembly is complete including the fuel lines, cap assembly, and fuel filter. The fuel tank assembly is sold individually.

This is an authentic manufacturer-sourced component that is specially designed for Homelite chainsaws. The stud is utilized to support the housing for the starter recoil assembly, please make sure to refer to the appropriate diagrams of your model for the correct location and application of this part. This high-quality plate is made of du...Read morerable metal and is sold individually, keep in mind the hardware to secure it is sold separately.

The adjustment pin attaches to the adjustment rod. It is an OEM replacement part for use in Homelite chainsaws. This item is made of metal and is available individually. A screwdriver may be required to replace this part if it becomes broken.

This is an authentic OEM part. The oil pump outlet tube is made for use with many chainsaw devices. Fitted onto the oil pump assembly, this plastic item is fitted onto the cone spring. This component is sold individually. Screwdrivers, pliers and a wrench are often required for the installation. The oil pump outlet tube is also included with the oil tank & cap assembly (310550001).