UT-10779-A Homelite Chainsaw - Parts

This genuine OEM replacement part is for use with chainsaws. The metal pin is used to adjust the bar when the bar adjustment screw is engaged. This special guide bar adjustment pin is sold individually, please see model diagram for any additional parts.

This is a Manufacturer Sourced replacement part for Lawn and Garden equipment. This item is Metal an is Sold Individually. A lock nut is a type of nut that resists loosening when properly threaded onto a bolt. This Locking Nut has multiple uses based on your tool. You would need a Wrench to tighten or loosen this Hex Nut.

Genuine OEM replacement part, this item is sold individually. The purpose of the 631036001 Guide Bar Plate is to assist in keeping the Chainsaw Blade inline. Also with out this plate, if the chain was to come of the chain bar, this part would help keep the housing of the Chainsaw from being damaged.

This is a Genuine Manufacturer Sourced replacement part designed for use with Homelite Chainsaws. This part is made out of metal and in this assembly it includes One (1) Sprocket Drum, One (1) Bearing and a Single (1) C-Clip. When replacing this part on a Chainsaw you would need a Socket Wrench Set, Flat-Head Screwdriver and a Hammer. ...Read moreDisassembling the Chainsaw: • Remove the chain brake, bar, and chain. • Remove the cover and spark plug. • Bind the piston. • Remove the clutch. Reassembling the Saw: • Replace the sprocket and clutch drum. • Seat the clutch. • Unbind the piston. • Replace the bar, chain, and chain brake. • Tension the chain.

Ergo grip starter handle

Genuine OEM replacement part, this item is sold individually. This is part of the Guide bar adjustment kit. The chain bar is sandwiched between this part and part number 631036001 Guide Bar Plate. You can obtain the complete Guide Bar Adjust Kit, by ordering part number UP06966A.

This rope is part of the pull starter system on Homelite and Ryobi gas powered lawn and garden equipment. It is an authentic manufacturer sourced replacement part, not an aftermarket equivalent. When the rope is pulled to start the engine, it is returned back into the starter pulley by means of the starter spring which is sold separately....Read more Please note, this rope is made out of strong fabric and it is sold individually. Replacing this starter rope you will need a screwdriver. • Remove the housing-cover • Remove the carburetor • Disconnect the clutch housing • Bind the engine • Remove the clutch drum • Remove the clutch • Remove the starter • Remove the starter handle • Remove the recoil pulley • Remove the old rope • Install the new starter rope • Reassemble and test the unit

This is an authentic replacement screw which is supplied by the original equipment manufacturer for use with handheld lawn and garden equipment. It is a standard hardware which has multiple applications depending on the model of your unit, please make sure to check appropriate diagrams for correct location and use of this item. This high-quality Torx screw is made of durable metal and it is sold individually.

This is a genuine OEM sourced part that is intended to be used with Homelite chainsaws and Ryobi pruners and chainsaws. The plastic oil cap is used to cover the oil tank fill spout to prevent spills and to stop contaminants from entering the tank. The cap includes the tether that connects the cap to the tank and the cap is priced as a single item.

This replacement clutch assembly is utilized on Homelite and Ryobi chainsaws. It is a genuine OEM sourced item, not an aftermarket equivalent. A centrifugal clutch connects two concentric shafts with the driving shaft nested inside the driven shaft. Keeping an eye on equipment performance will determine when the centrifugal clutch require...Read mores replacement. Please note the clutch drum, spacer and washer are all sold separately. This clutch is made from durable metal material and it is sold individually. To complete this repair you will need a screwdriver and pliers.