UQC061ALMK1 (AWYAUSL) LG Air Conditioner - Overview

Diagrams for UQC061ALMK1

See every part. Know exactly what you need.

Part List

Parts for the UQC061ALMK1

Thermistor,NTC

★★★★★

(1)

Part #6323A20012C

This part is a thermistor assembly and it works in conjunction with your room air conditioner. The thermistor is a sensor that attaches to the control board of your air conditioner. Once attached it will help regulate and monitor the temperature within the room. This model measures to be slightly under 20 inches in length, and it is black...Read more

Read less

$8.55

Clamp,Spring

★★★★★

(1)

Part #3H02932B

This spring clamp is designed for your room air conditioner. This clamp holds the fan blade on the motor shaft so it can rotate during operation. If your fan blade is wobbling on the motor shaft, you may need to replace it. The part is made of metal and is approximately 3/4-inch in diameter. This is an OEM part sourced directly from the m...Read more

Read less

$75.13

PCB Assembly,Display

Part #6871A20707A

GRILLE ASSEMBLY,FRONT(IN

Part #3531A20168M

Curtain Installation Kit

Part #3127A20083A

This is used for window air conditioners.

$8.55

Louver,Vertical

Part #4758A30037A

Capacitor,Film,Box

★★★★★

(1)

Part #0CZZA20001W

Overload Protect

Part #6750U5L007A

$94.13

POWER CORD ASSEMBLY

Part #EAD63469501

DAMPER,COMPRESSOR

Part #5040AR4195E

PCB Assembly,Main

Part #6871A20706A

Fan Assembly,Cross Flow

Part #5901A20020A

Common Symptoms of the UQC061ALMK1

How this model fails, and the parts that fix it.

Does not shut off

Fixed by
these parts

Show All

Repair Tips From Fixers Like You

See how others fixed this model. Time, tools, difficulty, and steps that lead to victory! View More

Bad thermistor

1 person found this instruction helpful.

Cindy from Baltimore, MD
Really Easy
15 - 30 mins
Screw drivers

Took front cover off air conditioner and pulled it a little forward out of the outdoor housing. I then flipped the LED display section out to the left and exposed the patch panel. The next step was to remove the panel with a small screwdriver and disconnect the old thermistor plug. I then plugged in the new one, remove the old one from th ... Read more

Read less

Was this helpful?

Bad thermister, unit would run constantly without cycling.

0 of 2 people found this instruction helpful.

Gary from Aurora, CO
Really Easy
Less than 15 mins
Screw drivers

Remove the front cover. Slide the unit forward a few inches from the case. Remove 1 screw from the top on the control box. Unsnap the old thermister leads going into the circuit board. Snap in the new thermister and place the end in the plastic holder in front of the coils. Install front cover.

Was this helpful?