TPK140JN3D Kelvinator Refrigerator - Parts

The evaporator fan motor kit is specifically made for your refrigerator to run the evaporator fan in your refrigerator. It is mounted on the center hub and has three lead wire terminals; its shaft has a diameter of 1/8 inches and is 1-1/4 inches long. The function of the evaporator fan motor is that it supplies air to the evaporator coils...Read more which then circulate cool air throughout your refrigerator, efficiently keeping your fresh food compartment cold. The tools you will need for this installation include a 1/4 inch nut driver, and a pair of wire strippers. Keep your hands protected during this repair by wearing work gloves.

This evaporator fan blade is a genuine OEM part that is sourced directly from the manufacturer. The evaporator fan blade circulates air through the refrigerator to control the amount of cold air goes that goes to internal compartments of the unit. It may need to be replaced if the fridge is noisy or not cold enough. This part is made of p...Read morelastic and is sold individually. It will be necessary to disconnect power to the refrigerator and empty the freezer compartment of the refrigerator. The tools needed to complete this repair are a 1/4 inch nut driver and a pair of needle nose pliers.

Sold individually.

This white door gasket is used to make an air-tight seal for the cabinet when the door is closed.

This white hinge pin bearing pivots the freezer and refrigerator door.

Sold individually.

1/4" x 5/8"

This almond door gasket is used to seal the refrigerator door when closed to keep the cool air inside and the room air out.

This push-on nut can be used for a variety of household appliances. To find the exact location and proper application of this part, refer to your appliance manual. Push-on nuts, also known as push-on retainers or push-on fasteners, allow components to be easily and securely assembled to a smooth shaft. A push-on nut has radial teeth that ...Read moreare formed at an angle perpendicular to the target shaft. The angled teeth allow the nut to slide onto the shaft in one direction while resisting motion in the reverse direction. Remember, to ensure the nut properly holds the shaft securely in place, it is important that the shaft material is softer than the nut.