TPJ24PRBABB General Electric Refrigerator - Instructions

After hunting around I found that the inlet water valve was leaking. I turned off the water and ordered a new part from Part Select. It came and I put it in. I had to disconnected the three water lines (one in, two out) and the electrical connections. Keep track of what came from where. I plugged everything back into the new valve. ... Read more Piece of cake.

replaced it with a new updated water valve. It was a bit different however the basics were the same-had great instructions with the valve-box is 21 years old so was a little worried about finding the part--thanks to the internet I found your great ad and info was easy to pull up-schematic sure helped. Now enjoying my Jack Daniels with p ... Read more erfect ice. Thanks a million. Bob Valdepena

Removed the hoses and the old valve; numbered the electrical and hose connections on the old wires and valve with a marker to make connection easier;

Had to cut the hose fittings, since the new valve was a simple hose insertion and the old had screw-on fittings.

Installed the new valve. The ice maker works fine. H ... Read more owever, the dispenser does not work; apparently there is no signal from the switches to the devices. But at least I have ice.

Removed ice dispenser trim from bottom-up and then removed control panel by gently pulling up from the bottom. Removed four screws holding dispenser chute and then two screws holing flapper assembly. Replaced gnarly old flapper with a new one and put all removed pieces back together.

Shut the water off to it. Carefully moved the refrigerator away from the wall to avoid damage to the copper piped water. Removed the cardboard cover at the bottom and rear. Layed a towel down to catch water. unscrewed the copper water line from the leaky double valve unit. Removed the old double valve unit by unscrewing the single sup ... Read more port screw. Installed the new unit in reverse order without following the directions that suggested using the old support structure. Took the opportunity to vacuum the cooling coils while back there, but broke an impeller on the cooling fan which is requiring further maintenance. Be careful!

removed two screws holding water valve in place; pull out valve and remove water supply line; remove two water lines going into box; connect lines to new valve and reinstall

Turned the wire protector to the side. Turned out the old bulb and replaced it with the new. Turned the wire protector back in place and I'm like new.

remove old valve, water lines and electrical wires and replace water lines, duel water valve and wires

replace entire inlet valve (block)

remove the 'pop-out " frame around the door recess, you pry the flexable seal from around the ice despenser, have someone hold the unit with the wiring, remove the one screw that holds the door recess, and replace the new one. reverse the procedure. remember to unplug thr frig. first

Un-plugged the refrigerator, removed the existing water valve and pressure fittings; replaced the old tubing and reconnected the faston connectors using the two adaptors provided.

Took about 30 minutes.

Works fine although the sound of filling the ice-tray is a bit lauder that the previous valve.

Placed the glass shelf in the new shelf frame and the frame in the refrigerator.

I was unable to positively identify the replacement shelf frame on the GE web site. Part Select's exploded view made it a piece of cake!

really simple,take 2 nuts loose pull the hose out and then replace.took less than 30 minutes

Easy easy easy. Pulled the refrigerator out. Took off the old valve, cleaned around the connection, installed the new one, connected the tubing, turned on the water, connected the electrical connections, plugged it back in, checked for leaks, and walla...got water...Thanks for the help and great service. I even received the valve ship ... Read more ped standard delievery via Fed ex couldn't afford the overnight, and received the part next day... GREAT!!It took me 15 minutes to complete.

Uninstallrd old part by dis assemble. Then installed new part very easy access and installation