TPJ24PRBAAA General Electric Refrigerator - Instructions

After hunting around I found that the inlet water valve was leaking. I turned off the water and ordered a new part from Part Select. It came and I put it in. I had to disconnected the three water lines (one in, two out) and the electrical connections. Keep track of what came from where. I plugged everything back into the new valve. ... Read more Piece of cake.

Removed the hoses and the old valve; numbered the electrical and hose connections on the old wires and valve with a marker to make connection easier;

Had to cut the hose fittings, since the new valve was a simple hose insertion and the old had screw-on fittings.

Installed the new valve. The ice maker works fine. H ... Read more owever, the dispenser does not work; apparently there is no signal from the switches to the devices. But at least I have ice.

removed two screws holding water valve in place; pull out valve and remove water supply line; remove two water lines going into box; connect lines to new valve and reinstall

Removed ice dispenser trim from bottom-up and then removed control panel by gently pulling up from the bottom. Removed four screws holding dispenser chute and then two screws holing flapper assembly. Replaced gnarly old flapper with a new one and put all removed pieces back together.

Turned the wire protector to the side. Turned out the old bulb and replaced it with the new. Turned the wire protector back in place and I'm like new.

replace entire inlet valve (block)

remove old valve, water lines and electrical wires and replace water lines, duel water valve and wires

remove the 'pop-out " frame around the door recess, you pry the flexable seal from around the ice despenser, have someone hold the unit with the wiring, remove the one screw that holds the door recess, and replace the new one. reverse the procedure. remember to unplug thr frig. first

Un-plugged the refrigerator, removed the existing water valve and pressure fittings; replaced the old tubing and reconnected the faston connectors using the two adaptors provided.

Took about 30 minutes.

Works fine although the sound of filling the ice-tray is a bit lauder that the previous valve.

Placed the glass shelf in the new shelf frame and the frame in the refrigerator.

I was unable to positively identify the replacement shelf frame on the GE web site. Part Select's exploded view made it a piece of cake!

really simple,take 2 nuts loose pull the hose out and then replace.took less than 30 minutes

Repair went exactly like the video. With this video it was easy to make the repair. There were no surprises or problems and I felt confident in the videos instructions. It was like pushing the easy button.

Really easy- turned off ice maker, powered down appliance briefly. Removed ice maker by removing 3 screws with 1/4 nut driver. Unplugged ice maker from power supply. Removed and replaced solenoid arm assembly. Reversed steps and whammy - ice cubes dropped.

I followed the instructions to the letter and it was very simple replacement even down to cleaning out the dust & dirt. The water dispenser works just fine now- Thanks for the tips

Watched the video from your site and followed instructions, extremely easy after that.