TMK170SN8 Gibson Refrigerator - Instructions
Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Freezer and main compartment had wide temperature variations
-
Joseph from Tullahoma, TN
- Really Easy
- Less than 15 mins
-
Screw drivers
I first thought the defroster heater broke - took the back wall of the freezer off and cooling fins were fine. Then took the defroster timer out and opened it up. The contacts were badly burnt so the compressor and fan ran during only part of the cooling cycle. Replacing the timer took less than 5 minutes - turn off the power, remove o
... Read more
ne screw to take out the control box, cut the ground wire (new timer housing is plastic and does not have a ground connection), remove two screws to unmount the timer, unplug the old timer, plug in the new timer, fasten with two screws, put the control unit in and fasten with one screw, turn power back on.
Read less
Was this helpful?
Thank you for voting!
Refrigerator Ran Constantly, Was not Cooling as well.
-
Mark from Hertford, NC
- Really Easy
- Less than 15 mins
-
Nutdriver, Screw drivers
Looked up troubleshooting info on your web site. Decided to replace the defrost timer. Ordered it using Paypal. Received the Shipment in about 1.5 days in Rural NC. Watched Your Video, cut off power to the fridge, removed the top self and unbolted the panel, removed the defective defrost timer, installed the new one and re-installed the
... Read more
panel and top shelf. Set the timer to defrost to check the operation (looked inside the freezer to see that the defroster was glowing red - it was) waited about twenty minutes to ensure that the fridge started cooling again. Fixed!
Read less
Was this helpful?
Thank you for voting!
Refrig would not defrost
-
Robert from Jacksonville, FL
- Really Easy
- Less than 15 mins
-
Nutdriver, Screw drivers
Diagnosis: used wiring diagram attached to frig and determined cause could be wiring, heater element, thermostat or timer. After completely defrosting the frig (turned it off) I removed the rear cover in the freezer and looked for an obvious problem. None seen. Removed temperature select pod from the frig box and looked for obvious pro
... Read more
blems. None seen but defrost timer appeared poorly made. Repair: Since I had no practical way of checking the defrost cycle in operation, I checked probable failures on the Part Select website and saw defrost timer as most probable. I ordered the timer. Installed it. Waited a few days to make sure the frig went through a few defrost cycles then removed the freezer rear cover. There was no excessive frost buildup so I'm reasonably sure the repair was successful.
Read less
Was this helpful?
Thank you for voting!
Refridgerator not geting cold.
-
VINCENT from DEPTFORD, NJ
- Really Easy
- Less than 15 mins
-
Nutdriver, Screw drivers
Just followed the online instruction video .It was very easy.
Was this helpful?
Thank you for voting!
freezer cold--frig was warm
-
Robert from Chicago, IL
- Really Easy
- Less than 15 mins
-
Screw drivers
You guys at Partselect are the best!!! Went to your site, typed in my appliance symptoms, and received possible fixes. Ordered the suggested parts (under $50) on a Sunday night and got em Tuesday am. Installed the easiest one first and Voila!!!! Frig is working great. Thanks Bob S
Was this helpful?
Thank you for voting!
Refrigerator was not cooling
-
Scott from Norman, OK
- Really Easy
- Less than 15 mins
-
Nutdriver
Remove 4 screws that hold up overhead controls, this is also the part that holds the light. Unplug the timer and replace. Super simple and runs great now. After you plug it in it may take a few minutes to kick on the compressor but it will. Also I was pleased it was a factory Frigidare part. Price was right.
Was this helpful?
Thank you for voting!
Freezer Worked Fine, Refrigerator Was 47 Degrees
-
Allan E from Manhattan, IL
- Really Easy
- Less than 15 mins
-
Screw drivers
I went on partselect put in make and model number, a list showed the probable cause. I watched the how to video. When I received the part in short order I loosened 2 screws disconnected the wiring plug (sprayed it with contact cleaner) pluged it in, removed screws from old part put them in new one. Put timer back in its location and ti
... Read more
ghtened the screws. Very eazy, works fine.
Read less
Was this helpful?
Thank you for voting!
Overheat coils at the bottom inside of the freezer
-
Costas from new hyde park, NY
- Really Easy
- Less than 15 mins
-
Screw drivers
I pick up very fast at these kind of small jobs but because of my very busy schedule I decided to call (2 times) technicians about my problem but none of them had any idea. About my repair, I removed the grill at the bottom of the refrigerator, unscrew a small plate (located on the bottom left side) that's holding the defrost timer. I plu
... Read more
g on the new part, screw back the plate with the defrost timer and that was it. Don't forget to turn clockwise with your finger the timer until you hear a "click" and then turn it slightly more to the right. There is also a video on U-tube.
Read less
Was this helpful?
Thank you for voting!
Refregerator drain pan was cracked
-
Carlos from Sierra Madre, CA
- Really Easy
- Less than 15 mins
The drain pan fit to perfection on our Frigidaire refrigerator model FPE19V3AW1 from 1987(!!!).
Was this helpful?
Thank you for voting!
Freezer worked, Frig would not cool.
-
Dean from Sunset, SC
- Really Easy
- Less than 15 mins
-
Nutdriver, Screw drivers
Unplugged the frig. Removed temp control module from frig, 1 screw with nut driver. Activated defrost timer by rotating adjustment until 2 clicks are heard. Removed two timer mounting screws, unpluged timer, plugged in the new timer, mounted it to the control module with 2 mounting screws. Replaced control module with the 1 mounting sc
... Read more
rew. Closed door and plugged it up.
Read less
Was this helpful?
Thank you for voting!
at first auto defrost would not work so I had to take the frezer panel apart and defrost it with a hair dryer every ten days
-
thomas from Chepachet, RI
- Really Easy
- Less than 15 mins
-
Nutdriver, Screw drivers
pulled down the thermostat cover and unpluged the timer control and replaced it with the new part. total time to repair was about 15 min. there was a vidio on how to replace the new part that just informed me that I did it right!!!!very easy site to find what you are looking for!!!!
Was this helpful?
Thank you for voting!
freezer frosted up and air could not circulate to the food section, causing the temperature to get warm, 55 degrees
-
PAUL from WEIRTON, WV
- Really Easy
- Less than 15 mins
-
Nutdriver
I followed the procedure online and found the thermostat was ok, it had continuity when cold, and the heater coil was also ok, it too had continuity, therefore the problem was a bad defrost timer. the refrigerator works great, thanks parts select!
Was this helpful?
Thank you for voting!
the evaporator fan same time won't stater
-
Armando from Eagle pass, TX
- Really Easy
- 15 - 30 mins
-
Nutdriver
change the evaporator fan motor kit working perfect
Was this helpful?
Thank you for voting!
changed defrost timer
-
Gerry from Apache Jct, AZ
- Really Easy
- 15 - 30 mins
-
Nutdriver, Screw drivers
followed the video very esay
Was this helpful?
Thank you for voting!
the freezer coils were not defrosting so they would ice up and cut off the cold air into the refrigerator side
-
mark from murrieta, CA
- Really Easy
- 15 - 30 mins
-
Nutdriver, Pliers
there were three possible problems the timer, the thermostat, or the heating element.i replaced the timer first as that is the problem 65% of the time and that did not fix the problem, i replaced the thermostat and that did fix the problem. after watching the video on line from parts select i took the back off of the freezer from the insi
... Read more
de, defrosted the coils with a hair blower and then swapped out the thermostat which pops right off and i spliced the old connectors to the new thermostat. the heat shrink tubing that came with the part was a little to big so i put a smaller peice on each side for water proofing. that is what the cigarette lighter is for to supply heat to the heat shrink tubing.now that i have fixed that problem i may tackle the ice maker next
Read less
Was this helpful?
Thank you for voting!