TMH14XMT4 Estate Microwave - Instructions

Removed retaining screws and broken parts; inserted new grill and screws. Fin!

Easy to do. Remove the old screws where the tabs had been broken off. Install new vent and replace screws. MAKE SURE THE TABS ON THE BOTTOM ARE IN THE SLOTS.

removed old vent and replaced by snapping in and two screws inserted into right and left top connections.

Took out the turntable parts to ensure I ordered the correct cooking tray. Matching those with photos of related parts on PartSelect worked great. Put turntable drive and support ring in place and cooking tray went in very easily. Plan to order a second one to have on hand for this rental property.

Replaced the missing tray and unscrewed a couple of screws to remove broken grille tabs and retightened the screws to hold in the new grille. Very successful and very easy. Thanks

This is a very basic job that a ten-year-old can do. Simply remove two screws at the top of the unit, remove the broken pieces of grill, snap the new one in place, and replace the screws. Oh, yes, I also cleaned out the foam and aluminum filter and cleaned some of the grease from behind the filter.

replaced with new one

Glass plate arrived in less than two days. Placed the glass plate in Microwave and presto the microwave works like a charm.

submitted manufacturer info to website and voila! a new glass turntable arrived in 2 days. I don't do well with computers, my 23 yr. old daughter was impressed......couldn't be easier! thanx! will definitely revisit your site

Removed screws holding tabs from broken vent grill to microwave frame.

Carefully snapped new grill vent into slots on top of microwave and slid tabs into slots on top of the frame.

Replaced the two screws in the tabs.

Finished

took old vent grill and tabs off using phillip screwdriver. started putting new grill on and it wouldnt go on. got to looking and there are two more screws that you have to loosen up so the grill will go into place these two screws are between the two tabs at each end. caution do not over tighten the screws it will break the tabs. overall ... Read more easy to install.

Take out the screws, broken pieces of clip, then put in the new vent grill, replace the screws. Done!

All I had to do was open the microwave door and place the turntable on the designated grooves, wha lah it fit. I am now back in business. Thanks to partselect, I found my replacement, ordered and it was shipped in no time.

First remove two screws on top of microwave. Pull off old vent grill. Finally line up new vent grill (bottom edge first) then snap into place. Replace two screws on top of microwave.

This was a piece of cake! Less than 48 hours to get the part and 3 minutes to find and return the screwdriver and 3 to make the repair! I removed two screws, the old grill and then set the new grill in place and rescrewed the screws.