Models > TMH14XMD1 > Instructions

TMH14XMD1 Estate Microwave - Instructions

All Instructions for the TMH14XMD1
106 - 120 of 144
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
The glass tray in the microwave got chipped while i was washing it and started to crack.
I just opened the box and set it in. Took all of two minutes.
Parts Used:
Glass Cooking Tray
  • Amber from Loretto, PA
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
Was this instruction helpful to you?
Thank you for voting!
Replacement
Easy, perfect
Parts Used:
Glass Cooking Tray
  • George from Statham, GA
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
Was this instruction helpful to you?
Thank you for voting!
left something in microwave too long and burned parts
replaced burnt parts
Parts Used:
Drive Coupling RING-TURN Glass Cooking Tray
  • Norman from Angier, NC
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
Was this instruction helpful to you?
Thank you for voting!
old vent grille brackets broke off
Super easy! Just unscrewed remainder of the vent grille, saving the old screws as instructed on other reviews I read, and replaced vent grille with perfectly fitting new one...whole process took 15 min (while 9 months pregnant with a toddler hanging on my leg!) And partselect sent the piece with regular shipping in 2 days!
Parts Used:
Vent Grille
  • Andrea from Fresno, CA
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
  • Tools:
    Screw drivers
Was this instruction helpful to you?
Thank you for voting!
burnt out light bulb
The problem I have with changing the bulb is my microwave is an overhead one and therefore I cannot tip it on its side to easily replace the bulb. I have to drop the lid down and carefully install the new bulb from underneath.
Parts Used:
Light Bulb - 40W
  • Shirley from Londonderry, NH
  • Difficulty Level:
    A Bit Difficult
  • Total Repair Time:
    Less than 15 mins
  • Tools:
    Screw drivers
Was this instruction helpful to you?
Thank you for voting!
Broken plate
Took the replacement plate out of the box and put it in the microwave in seconds. I never realized how much of a difference having the correct microwave plate would make. It's great to have it back.
Parts Used:
Glass Cooking Tray
  • JASON from ABSECON, NJ
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
Was this instruction helpful to you?
Thank you for voting!
Did not have a mounting plate with our used microwave
My husband just installed the mounting plate on the wall and the microwave was placed in position and mounted in less than 5 minutes.
Parts Used:
Mounting Plate
  • Megan from Elverson, PA
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
  • Tools:
    Screw drivers
Was this instruction helpful to you?
Thank you for voting!
new grease and charcoal filters
removed old put in new.
Parts Used:
Charcoal Filter Grease Filter
  • SALVATORE from MIDDLETOWN, CT
  • Difficulty Level:
    A Bit Difficult
  • Total Repair Time:
    Less than 15 mins
  • Tools:
    Screw drivers
Was this instruction helpful to you?
Thank you for voting!
Bulb burned out
You had alerted that it was imperative to unplug unit before starting to remove defective bulb. As described, there was silicon on bulb and socket and bulb broke upon my attempt to remove. Had to use needle nose pliers to get metal base of old bulb from socket, then all went well.
Parts Used:
Light Bulb - 40W
  • Lester from Mesquite, TX
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
  • Tools:
    Pliers, Screw drivers
Was this instruction helpful to you?
Thank you for voting!
grille kept falling off until tabs broke
Looked at the original instruction manual to see how it was installed, removed the two Phillips screws, fitted the grille into position until correct, then replaced the two screws.
Parts Used:
Vent Grille
  • Marcelene from Cuyahoga Falls, OH
  • Difficulty Level:
    Easy
  • Total Repair Time:
    Less than 15 mins
  • Tools:
    Screw drivers
Was this instruction helpful to you?
Thank you for voting!
Microwave would not heat
Removed microwave case and bad part was right there in plain sight attached to the magatron. Two screws and two wires and part replacement was done. Plugged in microwave and works perfect. Couldn't have been any easier. Thanks for the easy troubleshooting and parts suggestions on your site.
Parts Used:
DIODE Thermal Fuse
  • Gary from Chesapeake, VA
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    15 - 30 mins
  • Tools:
    Screw drivers
Was this instruction helpful to you?
Thank you for voting!
Part missing
This rental unit was missing the vent grille for the mounted microwave. It was super simple to install and makes the microwave look like new.
Parts Used:
Vent Grille
  • Cheryl from Chula Vista, CA
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
  • Tools:
    Screw drivers
Was this instruction helpful to you?
Thank you for voting!
Burn't out bulb.
Removed the glass cover and replaced the bulb. Very simple.
Parts Used:
Light Bulb - 40W
  • Carter from McCordsville, IN
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
  • Tools:
    Screw drivers
Was this instruction helpful to you?
Thank you for voting!
The capacitor was melted in the microwave
My husband open the microwave and see the capacitor melted. He try to find the piece in store,but unfortunatly he didn't find any. I found the piece on the web and ordered it. My husband replaced the part easily. The microwave work very well.The microwave was to our friend. He did replace it by a new one. Now we have a new microwave with a fan.
Parts Used:
CAPACTR-MG
  • Jocelyne from Fort Pierce, FL
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
  • Tools:
    Screw drivers
Was this instruction helpful to you?
Thank you for voting!
Tabs broke off the old grille
Removed screws from microwave case. installed new grille. inserted screws into holes in case. Tightened screws to secure grille
Parts Used:
Vent Grille
  • Lynne from Raleigh, NC
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
  • Tools:
    Screw drivers
Was this instruction helpful to you?
Thank you for voting!
All Instructions for the TMH14XMD1
106 - 120 of 144
Back to Top