TM3000CX5 Makita Multi-Tool - Parts

Length 8 Foot Length: 6' Gauge: 18 Wires: 2 Type: Bare Wire This power supply cord is a genuine OEM sourced replacement part. It is specially made to supply power from a standard outlet to Makita power tools. A cracked or damaged cord should be replaced before continuing to use the tool. This rubber insulated cord is sold individ...Read moreually. It comes with a rubber sleeve grommet that is not sold separately. Replacing this power supply cord you will need a screwdriver. • Remove the housing screws • Remove the the housing • Disconnect the old cord wires • Remove the old power cord • Secure the new cord in place • Connect the wires • Reassemble and test the new cord

This tapping screw is an authentic hardware that is supplied by original tool manufacturer for use with a variety of Makita power tools. It has multiple uses depending on the model of your unit, please make sure to check appropriate diagrams for correct location and use of this screw. Note this durable metal screw is sold individually.

This Ball Bearing is sealed on both sides. This is a genuine Makita replacement part that is sold individually. • Ball bearings are used to reduce friction between rotating parts. The balls or rollers take the load and spin, distributing the weight evenly while the minimal contact area of the ball reduces friction. This reduces wear...Read more on the tool and allows it to run smoothly. • Bearings experience constant wear when the tool is in operation from pressure, heat, vibration and friction. Because of this, many Bearings need periodic maintenance or replacement.

The brush holder attaches to the carbon brush. This is a genuine replacement part sourced from the original manufacturer for use with grinders, multi-tools, and plate joiners made by Makita. This item is made of metal and is available individually. When replacing this part a screwdriver might be required during the installation process. It may become broken and will need to be replaced.

Included in part number 515616-3

This is a genuine manufacturer-sourced part which is specially designed for Makita sanders, jig saws, and routers. This cord guard is used to protect the power cord from getting damaged. No tools are required to install the cord guard, simply slide the power cord in place through the cord guard. This part is made of rubber and is sold individually.