TLE-550 Tanaka Edger - Parts

This is an authentic Tanaka replacement part, sourced from the original manufacturer for use with outdoor power equipment. The special cylinder gasket is commonly used to form a seal between the cylinder and the crankcase. It is recommended to replace gaskets when servicing the engine to ensure proper seals when the parts are reinstalled. This gasket is available as an individual replacement part.

This is an authentic Tanaka replacement part, sourced from the original manufacturer for use with small engines. The special gasket is used to seal the connection between the two halves of the crankcase. It is recommended to replace gaskets when servicing the engine to ensure proper seals when the parts are reassembled. This gasket is available as an individual replacement part.

This is an authentic Tanaka replacement part. The wheel is designed by the manufacturer for use in edgers. This part is made of plastic and rubber, and is used to allow the machine to move easily. You will require a wrench when replacing this part. This item is sold individually.

This is a genuine Tanaka replacement part. The handle-lock is found in Tanaka edgers. This part is a high-quality plastic knob attached to a metal bolt. It is used to hold or loosen the handle for adjustment. No tools are required to replace this item. Simply remove the old part and screw the new one into place. This part is sold individually.

It is an authentic Tanaka part that is supplied by the original manufacturer for use with a variety of equipment. The bolt helps to secure the clutch arm. This is an identical replacement for a missing or faulty bolt that was installed on a new unit. Please make sure to refer to the appropriate diagrams of your model for the correct locat...Read moreion and application of this hardware. Keep in mind this high-quality part is made of durable metal and is sold individually. A wrench will be needed to secure or remove it.

This is an authentic Tanaka replacement part that has been sourced from the original manufacturer to be used with walk-behind edgers. The metal spring is used to link the control cable and the governor control lever. This item reduces the change of damaging the cable or lever when torsion is applied to pull the cable. This item is availab...Read morele as an individual replacement part, please note pliers may be needed to install the spring.