- Home
- TGK210KN0D
- Instructions
TGK210KN0D Kelvinator Refrigerator - Instructions
Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Refrigerator too Warm
-
Raymond from Yorktown Heights, NY
- Easy
- Less than 15 mins
-
Nutdriver, Screw drivers
tested the thermostat, cleaned the coils, checked seals all clean. defrost timer did not cycle so replaced it but issue not resolved. even though freezer was working while refrigerator was problematic, proceeded to open freezer panel. discovered that fan was not pushing cold air into refrigerator compartment due to ice build up in conne
... Read more
cting tubes. cleaned ice and replaced panels to positive result
Read less
Was this helpful?
Thank you for voting!
Faulty defrost timer. Freezer would not maintain temperature
-
Steve from Nineveh, IN
- Easy
- Less than 15 mins
-
Nutdriver
Watched the video once. Removed four 1/4 inch screws with a nut driver unplugged the unit, took out two screws securing the timer. Replaced did all of this in about 10 minutes. It was "exactly" as the video showed and it's worked perfectly since the replacement of the faulty timer. I saved a $75.00 service call minimum and the part was mo
... Read more
re than likely cheaper from Part Select than from the repair facility. Although I'm a pretty good handy man, you would not need any experience to make this repair. The instructions are precise and the part fit perfectly.
Read less
Was this helpful?
Thank you for voting!
freezer was freezing and no refrigerator
-
Michael E from Uniontown, PA
- Really Easy
- Less than 15 mins
-
Nutdriver, Screw drivers
Followed instruction vedeo from partselect. THANKS!!!!!
Was this helpful?
Thank you for voting!
Freezer was cold bit the refrigerator was warm.
-
Christopher from Wilmington, DE
- Easy
- Less than 15 mins
-
Nutdriver, Screw drivers
Based on the diagnosis on this site I thought the 66% odds of the problem being the Defrost Timer looked pretty good, $30 including shipping versus a Sears tech phone estimate of $250-300. BINGO! Just follow the online installation instructions and don't forget to use the reset switch as described. Works like new! THANK YOU
Was this helpful?
Thank you for voting!
freezer frosted up and air could not circulate to the food section, causing the temperature to get warm, 55 degrees
-
PAUL from WEIRTON, WV
- Really Easy
- Less than 15 mins
-
Nutdriver
I followed the procedure online and found the thermostat was ok, it had continuity when cold, and the heater coil was also ok, it too had continuity, therefore the problem was a bad defrost timer. the refrigerator works great, thanks parts select!
Was this helpful?
Thank you for voting!
Freezer & fridge warm / condenser coils iced over
-
Daniel from North Plains, OR
- Easy
- Less than 15 mins
-
Screw drivers
Problem not consistent. OK for 2-3 weeks, then freeze coils. Mark and observe the defrost timers manual rotating adjuster. Timer would stop mid cycle. One revolution equals 8 hours of compressor run time followed by 30 minutes of defrost. Replacing timer took 5 minutes.
Was this helpful?
Thank you for voting!
frig side not cool/freezer coils not defrosting
-
daryl from n.las vegas, NV
- Really Easy
- Less than 15 mins
unplugged frig,removed bottom front cover and loosend 2 screws at bottom front left and slid defrost timer out from behind metal panel,unplugged the old and plugged in the new.frig works great.
Was this helpful?
Thank you for voting!
Refridgerator not geting cold.
-
VINCENT from DEPTFORD, NJ
- Really Easy
- Less than 15 mins
-
Nutdriver, Screw drivers
Just followed the online instruction video .It was very easy.
Was this helpful?
Thank you for voting!
freezer cold--frig was warm
-
Robert from Chicago, IL
- Really Easy
- Less than 15 mins
-
Screw drivers
You guys at Partselect are the best!!! Went to your site, typed in my appliance symptoms, and received possible fixes. Ordered the suggested parts (under $50) on a Sunday night and got em Tuesday am. Installed the easiest one first and Voila!!!! Frig is working great. Thanks Bob S
Was this helpful?
Thank you for voting!
Refrigerator was not cooling
-
Scott from Norman, OK
- Really Easy
- Less than 15 mins
-
Nutdriver
Remove 4 screws that hold up overhead controls, this is also the part that holds the light. Unplug the timer and replace. Super simple and runs great now. After you plug it in it may take a few minutes to kick on the compressor but it will. Also I was pleased it was a factory Frigidare part. Price was right.
Was this helpful?
Thank you for voting!
Freezer and main compartment had wide temperature variations
-
Joseph from Tullahoma, TN
- Really Easy
- Less than 15 mins
-
Screw drivers
I first thought the defroster heater broke - took the back wall of the freezer off and cooling fins were fine. Then took the defroster timer out and opened it up. The contacts were badly burnt so the compressor and fan ran during only part of the cooling cycle. Replacing the timer took less than 5 minutes - turn off the power, remove o
... Read more
ne screw to take out the control box, cut the ground wire (new timer housing is plastic and does not have a ground connection), remove two screws to unmount the timer, unplug the old timer, plug in the new timer, fasten with two screws, put the control unit in and fasten with one screw, turn power back on.
Read less
Was this helpful?
Thank you for voting!
Refrigerator Ran Constantly, Was not Cooling as well.
-
Mark from Hertford, NC
- Really Easy
- Less than 15 mins
-
Nutdriver, Screw drivers
Looked up troubleshooting info on your web site. Decided to replace the defrost timer. Ordered it using Paypal. Received the Shipment in about 1.5 days in Rural NC. Watched Your Video, cut off power to the fridge, removed the top self and unbolted the panel, removed the defective defrost timer, installed the new one and re-installed the
... Read more
panel and top shelf. Set the timer to defrost to check the operation (looked inside the freezer to see that the defroster was glowing red - it was) waited about twenty minutes to ensure that the fridge started cooling again. Fixed!
Read less
Was this helpful?
Thank you for voting!
Freezer Worked Fine, Refrigerator Was 47 Degrees
-
Allan E from Manhattan, IL
- Really Easy
- Less than 15 mins
-
Screw drivers
I went on partselect put in make and model number, a list showed the probable cause. I watched the how to video. When I received the part in short order I loosened 2 screws disconnected the wiring plug (sprayed it with contact cleaner) pluged it in, removed screws from old part put them in new one. Put timer back in its location and ti
... Read more
ghtened the screws. Very eazy, works fine.
Read less
Was this helpful?
Thank you for voting!
Not defrosting and then warm up do to ice
-
Bryan from Red Oak, IA
- Really Easy
- Less than 15 mins
-
Screw drivers
replaced the defrosting timer and saved a lot of $ by doing it my self.
Was this helpful?
Thank you for voting!
End cap clips broke
-
Wylie from Houston, TX
- Really Easy
- Less than 15 mins
-
Pliers
You just slide off the broken part and replace it with a new part. I had to make a slight adjustment to the end of the shelf rail to allow the new piece to properly mate with the old shelf rail.
Other Parts Used:
Was this helpful?
Thank you for voting!