TFF20RAB General Electric Refrigerator - Parts

The interior light of your refrigerator is controlled by a switch that is activated when the door is opened and closed. If your refrigerator light will not turn on, there could be an issue with the switch. The switch is spring loaded and is a generally closed type of switch meaning there should be no continuity when the button is depresse...Read mored, and continuity through the switch when the button is not depressed. This plastic, white, OEM switch is sourced directly from the manufacturer, is sold individually and is easy to replace. The repair usually takes less than 15 minutes and requires a flat blade screwdriver and needle nose pliers.

The drawer slide rail in your refrigerator allows the door bin to slide in and out efficiently. If the slide rail is broken or missing it will need to be replaced. This slide rail is sold individually, and is for the left side of your refrigerator drawer bin. Be sure to order the correct replacement rail for your drawer. The rail is approximately 15 inches wide and is made of white plastic.

This is a replacement drawer slide rail for your refrigerator. The slide rails allow the crisper pans to slide in and out efficiently. If the slide rail is broken or missing, the crisper pan will not be able to slide into position. This slide rail is for the right side of the refrigerator and is sold individually, so be sure to order the ...Read moreslide rail for the correct side. This part is made of white plastic and is approximately 15 inches in length. This is an OEM part from the manufacturer.

Found at the end of the auger in the ice container - replace when the icemaker doesn't dispense ice.

This kit features a 5-blade plastic evaporator fan blade that rotates CCW and measures 4.5-inches in diameter and has a 3/8-inch-tall shaft. This kit also has a metal compression ring that secures the fan to the evaporator. The evaporator mechanism is normally located in the freezer and is responsible for pulling the warmer air over the c...Read moreondenser coils, cooling it off and then blowing and circulating that cooler air through the rest of the refrigerator. If the freezer compartment has a frost buildup or if there is a lack of cooling and airflow in your refrigerator, this fan likely needs to be replaced. To replace your evaporator fan, you will likely need a screwdriver and a set of pliers and check your user manual for the exact location of your evaporator fan.

When activated, the auger rotates and pushes ice out of the bin through the chute to the user.

This refrigerator defrost thermostat will cut out at 55 degrees F and kick back in when the temperature drops to 35 degrees F. It comes with connectors and the mounting brackets.

This condenser fan motor operates in a clockwise fashion. The fan itself has two 1/4 inch spade terminals. It carries 2 watts and 115 volts. This motor NO longer comes with cover for terminals.

When the switch is activated it will distribute ice down through the ice chute.

The defrost control in your refrigerator acts like a clock. It continually advances and alternates between activating the cooling cycle and the defrost heater, keeping your refrigerator at the appropriate temperature. If you notice that your refrigerator seems too warm or too cool, you may need to replace the defrost control. This part is...Read more made of white plastic and contains 4 metal prongs that connect to your refrigerator. This part is sold individually. The defrost control is located at the back of your refrigerator, inside the control housing. To access this part, you will need to unhinge your light cover, and disconnect the air inlet assembly from the control housing.

Color is brown.