My Orders
TFF KIT 1 General Electric Ice Maker - Instructions
Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!
Search filter:
Clear Filter
Your search term must have 3 or more characters.
water line cracked
2 of 3 people
found this instruction helpful.
-
RUSSELL from BLACK HAWK, SD
- Very Easy
- Less than 15 mins
I loosened the compression nut on the valve with my fingers and pulled the water line free from the valve. On the other end, I just pulled it from the hose clamp. Installation in reverse. Force the water line into the fitting on top, Slide the old nut over the line on the bottom. Screw the nut onto the valve. Reach inside the freeze
... Read more
r and turn on the ice maker. Done. Before replacing the cardboard grill, you should vacuum the coils on the bottom, front and back. If practical, push it outside and blow it out with an air compressor or a leaf blower.
Read less
Was this helpful?
Thank you for voting!
ice maker pump and water line leaking
2 of 5 people
found this instruction helpful.
-
Edward from Jenks, AL
- Really Easy
- 15 - 30 mins
-
Nutdriver, Screw drivers
I replaced both the punp and water line. the website depicting the repair parts was the best i ever worked with. The parts were high quality delivered on time and easy to install. Total job cost $30 as opposed the cost of of a service man or a new refrig.
Was this helpful?
Thank you for voting!