TC200-2014B Tecumseh Engine - Parts

The Fuel Line Clamp is a metal, individually sold part which clamps onto the fuel line, securing it to a port and preventing leaks. Installation is rated as "Easy" by customers and will require pliers and a screwdriver. If broken due to wear/fatigue/damage, there may be a fuel leak and the part should be replaced. Refer to your make, model and diagrams to ensure this is the correct part.

This is replacement oil for your 2-cycle engine. Oil is important for your 2-cycle engine, as it helps to lubricate the engine parts during operation. This container of oil is 236mL or 8 fluid ounces. It is sold individually.

This is a genuine replacement part that has been sourced from the original manufacturer to be used with snow thrower engines from Husqvarna and Toro. The metal screw is used to fasten the fuel tank to the tank mounting bracket. This item is available as an individual replacement part, please note a hex socket wrench may be needed to install this item.

The fuel line is a rubber hose that is responsible for allowing the fuel tank to supply the carburetor and various engine components with fuel. This fuel line is designed to be compatible with various types of lawn equipment and is an authentic OEM part. Because it interacts with gas and oil frequently, it will eventually become brittle a...Read morend crack and need to be replaced. To replace it, you will need to drain the fuel from your equipment, remove the clamps securing the ends of the line, and then swap out the old line for the new, before installing the clamps back. Make sure to check the fuel line frequently for cracks and damage to prevent any leaks from harming your equipment and to maintain its health and performance.

This spark plug cover is supplied directly from the original equipment manufacturer. The rubber and metal component is often used in snowthrower engines, and is sold individually. The spark plug cover is fitted over the spark plug wire connection, providing protection. A screwdriver and pliers may be required for the removal and replacement.

This solid-state ignition coil module is designed to deliver a strong, consistent spark for reliable starting and smooth operation in small two-cycle engines. By converting flywheel energy into precise ignition timing with no mechanical points, it helps resolve common issues such as no-spark, hard starting, or intermittent misfiring. Buil...Read moret to OEM standards for durability and exact fit, it is an ideal replacement for restoring dependable performance in lawn and garden equipment powered by compatible Tecumseh engines.

This genuine OEM replacement part is made to fit the engines listed below. A fuel line clamp holds the fuel line onto the carburetor. Sold individually. • Access carburetor/fuel line connection • Pinch off fuel line about 1-2" from connection point • Squeeze tabs of old fuel line clamp with pliers; slide clamp away from carburetor ...Read moreuntil it is freed • With a screwdriver or other small prying tool, remove fuel line from carburetor • Remove old clamp and replace it with the new clamp • Reverse these steps to reassemble