T272X Shindaiwa Trimmer - Parts

This single-row, deep-groove ball bearing is sized at 12x32x10mm and is made of durable metal. It is used to reduce friction and vibrations when it is in between two parts that are rotating or moving against each other. This bearing can handle forces that are applied to it up-and-down and sideways, also known as radial and axial loads. It...Read more is easy to install and can handle high rotational speeds without causing too much vibration or making much noise. Over time, this ball bearing wears out from heat and pressure and starts to fail. If the engine of your machine has been run without oil in the gas tank, this ball bearing can seize. In these situations, you will need to replace the ball bearings. Otherwise, you will notice that your machine overheats, works harder because of the increased friction it is handling, and produces excessive vibration and noise. To extract a ball bearing from your machine, you will need to insert a flat-head screwdriver through the bearing opening and against the seal. Then, tap the seal out with a mallet. Afterwards, slot a socket through the diameter of the bearing, and tap the entire bearing out of its place by again using a mallet. This authentic OEM part is sold individually, so be sure to refer to your user manual to verify how many bearings your machine needs and where they are in it.

This spark plug cap is a genuine OEM sourced replacement part that is commonly utilized on Shindaiwa lawn and garden equipment. It is used to connect the spark plug to the ignition wire. Please note this durable rubber part is sold individually.

This is an original replacement part manufactured for use with outdoor power equipment. The special screw is used with several types of equipment and the screw may have multiple applications. This fuel pump cover screw is used to secure the primer cover to the air purge body and fuel pump body. The fuel pump screw is available as an individual replacement part, please see model diagram for part location and usage.

This is a genuine OEM replacement part designed to secure the blade on brush cutters/trimmers and edgers. Please note this is a hex head bolt which requires a wrench to secure it. This bolt is sold individually.

This manufacturer approved Spark Plug Terminal Cap is a part that is located inside the spark plug boot, and attaches to the spark plug to transfer the electrical current between the two. If broken, the spark plug will no longer get the electrical current it needs, and the part must be replaced. Installation is rated as "Easy" by customer...Read mores and requires pliers. This bronze, metal part is electrical and comes individually sold. Refer to your make, model and diagrams to ensure this is the correct part for you.

This is a genuine replacement part manufactured for use with outdoor power equipment. The special spring clip is commonly used to secure fuel lines. The spring clip is used with several types of equipment and can have multiple applications. This spring clip is available as an individual replacement part, please see model diagram for part location and usage.

This is a high quality OEM sourced replacement part that is designed for use with Shindaiwa handheld trimmers. The purpose of this item it to secure the air filter cover. Please note this high quality knob consists of a plastic grip with a threaded metal shaft and it is sold individually.

This is an authentic part from Shindaiwa for use in trimmers. The heavy duty air filter goes between the cleaner cover and the net and helps to keep dirt out of the engine. A wrench may be needed to replace this part. This air filter is sold as an individual replacement part and please note that the air filter-foam is sold separately.

The OEM Diaphragm Pump Gasket attaches to and prevents fuel leaks between the cover and the carburetor. It's a black part, rated as "Easy" to install by customers which requires a screw driver. If broken, there will be a leak. If broken, damaged, or worn the part must be replaced. Refer to your make, model and diagram to ensure this is the right part for you.

This cushion is an original part from Shindaiwa. Compatible with many lawn and garden trimmers, this item is constructed of durable plastic. The protective cushion is designed to fasten the tank assembly to the tank guard. You will need a hex wrench to make the repair. The cushion is sold individually. This part is also included in the fuel tank assembly (A038000160).