ST661BS ((1696410-01)(2015)) Murray Snow Blower - Parts

This hex bolt is sourced from the original equipment manufacturer. The bolt is designed to fasten two individual parts together in your lawn and outdoor equipment. It is made of steel to withstand harsh environmental conditions and measures 0.25 inches in diameter and 0.62 inches in length. The hex bolt gets its name from its hexagon-shap...Read moreed head, which makes it easy to grip with a wrench or socket. Before installing the new bolt, first clean the threaded hole where the bolt rests to remove any dirt or debris in the area. Once the area is clean you can place the bolt in position using your hands and tighten it using a wrench or socket. It is important not to overtighten as this could damage the area and the bolt. Sold individually.

Used to hold a shaft with a mating part, such as a gear, this Woodruff Key is sourced directly from the original manufacturer, is made of metal, is grey, and is sold individually, not as part of a kit or assembly. When this part becomes broken or damaged, it should be replaced. You may notice the mating shaft or gear will no longer rota...Read morete together if the part is malfunctioning. Customers rated this repair as Easy.

The washer goes between the bearing and the intermed sprocket. It is available as an individual replacement part. This item is an OEM from Murray, Snapper, and Simplicity for use in snowblowers. A wrench might be needed during the installation process. It is made of metal and will require replacing if it bends or breaks.

Spring ext idler 8-13

A genuine item which is supplied directly from the original equipment manufacturer for use with Murray and Snapper lawn and garden equipment. It is a standard hardware which has multiple applications depending on the model of your unit, please make sure to check the appropriate diagrams for the correct location and use of this screw. Keep...Read more in mind this high-quality component is made of durable metal and is sold individually.

This is a genuine Murray, Snapper, and Simplicity part sourced directly from the manufacturer for use in snowthrowers. The clutch spring boot is made out of rubber. A set of pliers may be necessary during the installation of this item. It may become broken and will need to be replaced. This is available as an individual replacement part.

Roller bearing .750idx1.2

Brng, fl .752idx1.002

This cable-augur drive is an original part from Murray for dual stage snow throwers and single stage snow throwers. This part attaches to the control lever that is on the control panel, which goes to the lever that is in the drive system. There are no tools that you need to replace this part. This cable-augur drive is made of wire, rubber and metal components. This part is sold individually.

It is an authentic OEM sourced item which is specially produced for use with snowthrowers, generators, and rear engine riders made by Murray, Briggs & Stratton, Snapper, and Simplicity. The nut is made of metal and attaches to the starter switch. During replacement, it may require a wrench to help install this part correctly. It may becom...Read moree broken or stripped and will need to be replaced. This part is available as an individual replacement.