ST385BC (UT-15040-B) Homelite Trimmer - Parts

This is a genuine OEM replacement part, sold individually. This Bumper helps keep the fuel tank in place, and minimizes vibration of the fuel tank. This part is used with a variety of string trimmers, compatible with the models listed below.

Fuel Tank with lines and fuel filter

This is a genuine OEM replacement part, it is sold individually. The purpose of the 900994004 Carburetor Gasket is to prevent an air leak, which would cause the engine to run poorly. It is advised to replace these gaskets when replacing or repairing the carburetor.

This is a genuine Homelite replacement part designed for use with Trimmers and Blowers. It is made out of Rubber and it is Sold Individually. By pressing on the Purge Bulb, it will force fuel into the fuel line from the fuel tank into the carburetor. Once the carburetor is full of fuel, the excess fuel will be purged back into the tank in...Read more the fuel return line. At some time the primer will lose its elasticity or crack and need to be replaced.

This is a genuine manufacturer approved replacement part. This specially designed heat dam is used on a variety of gas powered trimmers/brushcutters and edgers. This part plays an important role because it works as a spacer for carburetor allowing it to stay cool. This part is made out of plastic and it is sold individually. You will need a wrench to remove the carburetor when replacing this item.

This is a manufacturer approved replacement part designed for use with gas string trimmers. This tube is the fuel return line that returns fuel back into the fuel tank after the carburetor has been primed. It is made out of rubber and it is sold individually.

A genuine replacement part which is supplied directly from the original equipment manufacturer for use with Homelite and Ryobi handheld lawn and garden equipment. Please make sure to refer to the appropriate diagrams of your model for the correct location and application of this hardware. Keep in mind this high-quality screw is made of durable metal and is sold individually.

It is a genuine item that is supplied by the original manufacturer for use with Ryobi and Homelite handheld string trimmers. This washer-clutch is a special friction disk that helps to engage the clutch by ensuring a tight fit between connected components. It provides an identical replacement for a damaged or a missing hardware that was i...Read morenstalled on a new unit. Check the diagrams of your model for the exact location and the correct installation of this part. One durable metal washer is included. You may need a screwdriver and a wrench set to perform this repair.

This starter pulley is an OEM part direct from Ryobi. This part is compatible with a variety of lawn and garden devices. The pulley is most often fitted between the air baffle and the container w/spring within the starter assembly. Please consult specific manual and diagrams for repair instructions. This part is sold individually. A screwdriver and a hex key are usually needed in making the replacement.