SB21 - Parts

This black door gasket is used to seal the freezer door when closed.

This is the mechanics (motor/engine) of the cooling system. It kicks in whenever the thermostat demands cooling. ***NOTE: This part needs to be installed by a trained professional in appliance repair. It requires special tools and knowledge to do so.

Glass Not Included.

This cord clip, also known as a strain relief, is used in microwaves, refrigerators and air conditioners. The clip holds the cord in a certain position to ensure that it is not strained. This extends the life of a power cord on your appliance and relieves tension. Refer to the manual provided by the manufacturer for further installation i...Read morenstructions and accurate guidance. As a safety precaution remember to unplug your appliance from the power source and wear work gloves to protect your hands.

This genuine screw is supplied directly from the original equipment manufacturer for use with Craftsman walk-behind lawn mowers and snowblowers. Check the diagrams for your model to ensure the correct repair procedure. The square area under the head is designed to fit into a square hole in the workpiece. It is this square hole that restra...Read moreins the screw and keeps it from turning when the nut is tightened. This screw is made of high-quality metal and is sold individually. A wrench might be needed to replace this hardware.

This part is sourced from the original manufacturer and is intended to be used with snowthrowers from MTD, Yard Machines, Troy-Bilt, Yard-Man, and Cub Cadet. The shave plate attaches to the bottom rear of the snowthrower\\\'s auger housing. This item wears down over time because it is used to scrape against the ground to gather snow into the auger as the machine moves forward. The shave plate is sold individually.

This V-belt is designed for various makes and models of snowblowers and is a genuine OEM part made of high-quality rubber. It powers the auger and impeller from the transmission and fits within V-shaped grooves on pulleys. This belt measures 35 inches in length and .5 inches in top width. Belts can stretch and become worn over time and lo...Read morese their tension or break, thus requiring eventual replacement. It is recommended that you inspect the belts within your snowblower regularly to maintain the best performance from them and your snowblower and to avoid having to fix them during a snowstorm. To replace this belt, first, you must disconnect the spark plug. Using a socket wrench, remove the belt cover from your snowblower, if applicable. Once the cover is removed, remove the belt guide, which is used to prevent the belt from slipping off the pulley. Then release the tension on the auger cable by loosening its nut and disconnecting it from the main handle. You can then access and remove the auger V-belt by removing the securing screws holding the snowblower together. Clean the pulleys and attach the new belt, and then while holding the belt, bring the snowblower together and pull the belt around each pulley and secure the snowblower together. Reconnect the auger cable and add tension to it by tightening the nut, connecting the belt guide over the belt, and securing the belt cover and spark plug.