Quick Question!

Have you ever purchased from PartSelect.com before?

Models > SAGQ7070KS0 > Parts

SAGQ7070KS0 Electrolux Dryer - Parts

All parts for the Electrolux Dryer SAGQ7070KS0

Below is a list of all parts for the Electrolux Dryer SAGQ7070KS0. To find the repair part you need, you can browse the list below or you can narrow your choices by searching for a part by name or description.

All Parts for the SAGQ7070KS0
1-14 of 117
Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$29.32

Door Catch

The door catch on your dryer is an important part as it keeps your dryer door closed, in order to ensure no air or clothes can escape. This part works by holding the door strike, w...

$14.16

'M' Series Ignition Coil Kit

This kit contains two coils, one is a two-wire secondary coil and the other is a three-wire booster coil. Both coils in the ignition coil kit should be used together in the clothes dryer. Some of the symptoms that this kit could be a solution for are: If there is no heat, not enough heat, or clothes takes too long to dry. In this case, the gas valve coils can be defective and replacing this part will help. Customers rate this project as easy. Refer to the installation diagram for further instructions. For safety, unplug your dryer before repair.

$55.95

High Limit Thermostat

This high limit thermostat is used in a dryer and monitors the temperature to make sure it does not exceed 260 degrees Fahrenheit. When your dryer temperature reaches 260 it will c...

$80.42

Blower Housing with Blower Wheel

***Please Note: This part is a substituted part by the manufacturer. It may appear different, but should still work with your appliance.

$28.58

Control Thermistor

This part controls the temperature of the inside of the dryer drum and prevents the dryer from overheating. This part is located in the blower housing.

$8.72

Door Strike

The door strike is attached to the door of your dryer and holds the door closed. If your dryer door is not closing, this might be due to the door strike needing to be replaced. This is a simple repair that should only take a few minutes to complete. The package contains one strike. Open the dryer door, and use a flat head screw driver to snap the old strike out if it has not fallen out already. Simply push the gasket out of the way, squeeze together the strike and place inside of the opening. Wiggle to ensure it is set in place properly.

$22.09

Flame Sensor

This part senses the flame for heat allowing the gas valve to open. The most common issue that might arise that would indicate the flame sensor needs to be replaced is your dryer i...

$6.65

SCREW

$31.04

High Temperature Adhesive

This high temperature adhesive is used for installing felt and rubber seals on dryers. The tube contains 1 ounce of product. This adhesive is made to withstand extremely hot temper...

$25.17

FILTER

$6.86

SCREW

Sold individually.

$7.46

GASKET

This is a gasket, but you may also know it as a door seal, for your dryer. This part prevents heat loss during a drying cycle by keeping the area around the door sealed. This gasket is all black, and is made of extremely flexible material. The surface of this part is roughly half an inch wide, and a quarter inch thick. One side of the material is smooth, while the other side has clips to make your installation easier.

$16.62

LIMITER

$40.71

SENSOR-MOISTURE

All Parts for the SAGQ7070KS0
1-14 of 117