S651D Ryobi Sander Polisher - Parts

This is an original Ryobi replacement part manufactured for use with 1/4 sheet sanders. The pan head screw is commonly used to secure the sanding pad to the platen. This screw is sold individually, please see model diagram for associative parts.

This is an OEM part sourced directly from the manufacturer. The bumper is found in Ryobi sanders. This part is made of high-quality plastic, and is used to create space between the platen and ball bearing. You will require a screwdriver when replacing this part. This item is sold individually.

This is a genuine OEM sourced component which is specially designed for use with Ryobi sanders. This is a PSA hook and loop sandpaper. The rough side is called hook and soft side is called loop, the hooks engage into the loop and provide the closure mechanism. Keep in mind this high-quality 120 grit sandpaper is made of durable materials ...Read moreand is sold individually. Please make sure to refer to the owners manual for the correct application of this part.

This is an original Ryobi replacement part. The puncher is used with sanders. This part is made of high-quality plastic, and is used to punch vac holes in the sand paper to allow dust to be pulled away from the sanding surface. No tools are required when replacing this part. This item is sold individually. Does not have rubber padding.

This replacement part is supplied from original equipment manufacturer. This is a genuine Ryobi sandpaper designed for use with 1/4" sheet/pad sanders. This is a non-adhesive sandpaper, includes one (1) sheet per order. Installing non-adhesive sandpaper is easy and does not require any tools. • Make sure sander is unplugged • To re...Read moremove old paper, lift up lever and disengage it from the tab on the platen • This will release paper clamp • Remove old sandpaper • Next insert one end of new sandpaper approximately 1/2" under the paper clamp Note: 1/2 in. clamping of sandpaper is necessary for multi-sheet stacking of paper • Lift up paper clamp lever and lock into place • Apply downward pressure to conform sandpaper to platen • Wrap sandpaper around cushion • Lift lever on opposite end of sander and insert loose end of sandpaper under paper clamp • Fit sandpaper against cushion tightly • Lift up on lever and lock into place

This genuine OEM supplied 220 grit sandpaper is specially designed for use with Ryobi sanders. It is a non-adhesive sandpaper that clamps to the platen. The cushion on the sander is approximately 1/4 in. smaller than precut adhesive-backed sanding sheets. If desired you may want to trim off the overhang of sandpaper on the back side of cu...Read moreshion. The cushion has been made smaller so that multiple sheets of non-adhesive sandpaper can be installed. Please note this high quality item is sold individually.