S604221 Roper Snow Blower - Instructions

Replaced relay board

First disconnected power to the oven at circuit breaker box. Then, Removed top front control panel, held by four screws exposed when top oven door is opened. Was able to move control up and out of the way without disconnecting. The relay control panel is visible on the right. I was able to reach all connectors with needle nose plie ... Read more rs and then remove the panel with needle nose to release clips and use screw driver to gentle pry up. Installed new unit by attaching back connectors and then setting panel down onto clips. Finished with attaching front connectors. Reattach front control panel.

It was fairly easy a few tight spaces to reach in but all in all it was pretty straight forward

I disconnected the drive belt from the motor and ran the motor to isolate it from the rest of the mechanisms. This was the noise. I disconnected the water lines and electrical cord,laid the machine front down. I disconnected the motor plug,removed the two bracket to body bolts and lifted the motor out to the bench. I then transferred th ... Read more e bracket to the new motor and reversed the procedure to install the motor. The most difficult part was raising the machine back up alone,I suggest a helper.