RTS50 (1997) Cub Cadet Tiller - Parts

This Flat Washer is made of durable gold-colored metal and is an authentic OEM part. It is used to spread the load under a bolt or nut and is sold individually. This part will need to be replaced if you notice any signs of cupping, corrosion, or other damage. Customers rate this repair as Easy.

This is an authentic replacement part manufactured for use with garden tillers. The shaft seal is used to seal the connection where the gear shaft connects to the gearbox housing. This shaft seal is sold as an individual replacement part, please see model diagram for associative parts.

This piston ring set is designed to create a tight seal between the piston and cylinder wall, helping restore proper compression and reduce oil consumption in small engines. By improving sealing efficiency, it supports smoother starting, steady power, and reliable overall performance. Ideal for replacing worn or damaged rings, it helps extend engine life and maintain consistent operation.

This is a genuine replacement part sourced from the original manufacturer for use with small engines. The metal hex nut is used to fasten the engine's flywheel to the crankshaft assembly. This item is available as an individual replacement part, please see diagram for related items.

This spark plug cover is supplied directly from the original equipment manufacturer. The rubber and metal component is often used in snowthrower engines, and is sold individually. The spark plug cover is fitted over the spark plug wire connection, providing protection. A screwdriver and pliers may be required for the removal and replacement.

This O-ring is designed for use with small engine carburetors and is made of rubber, meaning over time and further exposure to fuel, it will become brittle and crack. This O-ring is installed within the carburetor and is located between securing screws near the base. If disassembling your equipment to replace this O-ring, it is recommende...Read mored you inspect the other parts to ensure optimal performance and to prevent any leaks. Featuring an inner-diameter of approximately 0.25-inches, the replacement process for this O-ring in your engine will vary, so check the user manual for exact location of this part.

This is an authentic MTD tiller replacement part. The hex B-tap screw is used to fasten the cable barrel holder to the clutch lever to ensure good tension on the clutch cable. The part is made of durable metal. You will need a wrench to replace this piece. This item is sold individually.

This Bell-Wash Flat Washer is an OEM part that measures .40 inches I.D. x 88 inches O.D. This washer is a silver, metal, washer sold individually. This part is rated as Easy to install by customers. If missing or damaged (likely due to fatigue) it should be replaced. Refer to your owners manual to ensure this is the correct part for you.