RT217MCH0 Frigidaire Refrigerator - Instructions
Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!
Search filter:
Clear Filter
Your search term must have 3 or more characters.
refregirator too warm
-
HUNG from KENT, WA
- Really Easy
- 15 - 30 mins
-
Nutdriver
I order defrost timer then replaced it but it seemed doesn't work. I order defrost thermostat again then it worked fine until now. Thanks. Part selects.
Was this helpful?
Thank you for voting!
Weird Noise that continued for at least 60 seconds control OFF.
-
Donald from Round Rock, TX
- Really Easy
- 15 - 30 mins
-
Nutdriver, Screw drivers
Unplug the refrigerator. Removed the right hand top shelf. Used a 1/4" nutdriver to remove rear center mounting screw for Control Housing. Used Phillips screwdriver to remove two mounting screws for timer. Unplug cable from timer and plug it into the new timer. Install the new timer and re-install the Control Housing. Plug in the refr
... Read more
igerator and adjust the timer to start the unit. This was a snap with the diagnostic provided by Part Select. At first I thought it was the fan rubbing but when I removed the cover (two screws) it was obvious that wasn't the problem. The diagnostic hinted that it was either the timer or the motor capacitor making the noise. Because the noise continued after turning OFF the control, I thought it was the timer...I was right.
Read less
Was this helpful?
Thank you for voting!
gasket was torn
-
Stephen from West Columbia, SC
- Really Easy
- 15 - 30 mins
-
Screw drivers
removed everything from door, removed screws in gasket around door, laid door face down(insulation side up)applied rtv around edge of gasket and door, waited 10 minutes and started with top screw in middle of top then middle of sides and bottom then installed remaining screws checked levelness of refrigerator, the you are done
Was this helpful?
Thank you for voting!
the evaporator fan same time won't stater
-
Armando from Eagle pass, TX
- Really Easy
- 15 - 30 mins
-
Nutdriver
change the evaporator fan motor kit working perfect
Was this helpful?
Thank you for voting!
changed defrost timer
-
Gerry from Apache Jct, AZ
- Really Easy
- 15 - 30 mins
-
Nutdriver, Screw drivers
followed the video very esay
Was this helpful?
Thank you for voting!
Frig did not run
-
hugh from delray beach, FL
- Really Easy
- 15 - 30 mins
-
Screw drivers
Simply replaced the defrost timer located inside the frig just behind the temp dial. Very easy job. Removed the 3 screws holding the temp sw and light assembly. Removed the defrost timer w/ 2 screws and put i all back together. 15 mins at most. Suggest you watch the install video for pointers.
Was this helpful?
Thank you for voting!
My Frig Light Stopped
-
Susan from Rapid City, SD
- Really Easy
- 15 - 30 mins
-
Screw drivers
I am a 65 year old woman with no mechanical aptitude: I just unplugged the frig. And used a screw driver to pry of the plastic socket from its outside edge. . Then you just unplug two tiny contact plugs that appear when you pull out the socket and replug in those two the same way on the new part. Pop the socket back into the hole . .
... Read more
. . And screw in the new bulb. I knew I needed the socket part cause when the bulb burned out , a new bulb still did not work. . . If I can do it, anyone can!
Read less
Other Parts Used:
Was this helpful?
Thank you for voting!
Fridge was warm and no cold air was coming in
-
gustavo from gilroy, CA
- Really Easy
- 15 - 30 mins
-
Pliers, Socket set
The repair was straightfoward. The evaporator motor I received from partselect was a different model with different wiring configurations. I cut the wires from the new motor per the instructions I received with the new motor and I did the same with the wires that connect to the fridge. Once I matched the wires and secured them with elec
... Read more
trical caps I began to put the evaporator motor to the base and started screwing the screws the way I took them off. Once I connected the wire harness to the back of the freezer and turned it on I noticed a big difference in air flow. I was surprised at how easy it was to fix my refrigirator problem. It's been a few weeks now and the fridge is cold and working like it should. Don't be afraid of this task. it's very easy and will save you a ton of money. Thanks partselect.
Read less
Was this helpful?
Thank you for voting!
Freezer wouldn't go in to defrost cycle
-
John from Long Beach, CA
- Really Easy
- 15 - 30 mins
-
Nutdriver, Screw drivers, Socket set
After some troubleshooting to ensure the thermostat and heating element were working, determined that the defrost timer was the problem. With the defective part, I was able to manually advance the timer to activate the defrost cycle, but it wouldn't do so on its own. Unplugged the refrigerator from the wall. Timer is located in the refrig
... Read more
erator compartment at the very top. The compartment houses the cooling thermostat, the light bulb and the defrost timer. Using 1/4" nut driver, remove 4 screws holding compartment cover to top of fridge. Lower a bit to access electrical wiring. Wiring harness can be unplugged to work on the timer away from the fridge which makes it a bit easier. Timer is mounted with 2 phillips head screws. Remove screws and unplug timer from wiring. Install new timer, plug in wiring, secure with the phillips head screws and remount entire compartment.
Read less
Was this helpful?
Thank you for voting!
Freezer dripped water and items thawed but compressor ran.
-
James from Montross, VA
- Really Easy
- 15 - 30 mins
-
Screw drivers
Instructions from partselect were very clear and probable cause made it easy to narrow things down. I have the manual for the refrigerator that shows the location of the defrost timer. Very surprised that it turned out to be a cheap and easy fix.
Was this helpful?
Thank you for voting!
Coil, in freezer kept freezing up, refrigerator did not stay cold
-
Janet from East Wenatchee, WA
- Really Easy
- 15 - 30 mins
-
Screw drivers
Removed the timer, installed the new one. Great service from part select
Was this helpful?
Thank you for voting!
Refridgerator compartment warm but freezer frosty
-
Kenneth from Glenmoore, PA
- Easy
- 15 - 30 mins
-
Nutdriver
First I replaced the defrost thermostat, then I realized that the evaporator fan would stop turning periodically. I could restart it by spinning the fan with my finger. The fan is behind a cover in the back of the freezer. If you remove the cover and check on the fan when you hear the condenser fan in the back running. (They seem to ru
... Read more
n at the same time.) It was easy to replace the fan and the new one is more powerful than the original. The refrigerator runs fine now. Thank you for this great site. Saved me a lot of $$.
Read less
Was this helpful?
Thank you for voting!
Fan Motor Malfunction
-
Donald from Waynesburg, PA
- Easy
- 15 - 30 mins
-
Nutdriver
Followed the instruction video. Removed the old one. Attached the fan blade, ground wire and connected power plug. Reinstalled with 2 screws. Works great.
Was this helpful?
Thank you for voting!
the fridge was freezing all the food.
-
Jim from Coulee City, WA
- Easy
- 15 - 30 mins
-
Nutdriver, Screw drivers
I watched the video you had on-line and it was simple. Thank you so much
Was this helpful?
Thank you for voting!
fridge not blowing cold
-
wayne from marietta, GA
- Easy
- 15 - 30 mins
-
Nutdriver
bottom left cornerof fridge defrost timer replaced two bolts and a wire
Was this helpful?
Thank you for voting!