EasyApplianceParts is now PartSelect! We've merged our sites to provide a better shopping experience for you.   Full Details
✖

Find Parts

Parts Departments

Top Model Types

Top Brands

Repair Help

Expert Repair Videos

Keep typing for more specific results...

RT216TLD0 Frigidaire Refrigerator - Instructions

All Instructions for the RT216TLD0
106 - 120 of 214

Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!

Search filter:
Clear Filter
Your search term must have 3 or more characters.
It would freeze up or not cool at all, depended where the clock stopped.
  • Roger from Owatonna, MN
  • Really Easy
  • 15 - 30 mins
  • Screw drivers
Removed the lower trim panel from front of fridg. and loosened two screws enough to turn it about 1/4 inch so the screw heads were in the larger holes. Pulled it out disconnected the wire connector and transfered the heat shield and screws to the new clock, connected the wire connector and aligned the screws. tightened them and job done. Has worked like new sense. Thanks Roger
Was this helpful?
Thank you for voting!
Refridgerator compartment warm but freezer frosty
  • Kenneth from Glenmoore, PA
  • Easy
  • 15 - 30 mins
  • Nutdriver
First I replaced the defrost thermostat, then I realized that the evaporator fan would stop turning periodically. I could restart it by spinning the fan with my finger. The fan is behind a cover in the back of the freezer. If you remove the cover and check on the fan when you hear the condenser fan in the back running. (They seem to ru n at the same time.) It was easy to replace the fan and the new one is more powerful than the original. The refrigerator runs fine now. Thank you for this great site. Saved me a lot of $$.
Was this helpful?
Thank you for voting!
the fridge was freezing all the food.
  • Jim from Coulee City, WA
  • Easy
  • 15 - 30 mins
  • Nutdriver, Screw drivers
I watched the video you had on-line and it was simple. Thank you so much
Was this helpful?
Thank you for voting!
Fan Motor Malfunction
  • Donald from Waynesburg, PA
  • Easy
  • 15 - 30 mins
  • Nutdriver
Followed the instruction video. Removed the old one. Attached the fan blade, ground wire and connected power plug. Reinstalled with 2 screws. Works great.
Was this helpful?
Thank you for voting!
both ref&frez were hot
  • Gary from Dunnellon, FL
  • Really Easy
  • 15 - 30 mins
  • Nutdriver, Screw drivers
1 went with maj 69% said defrost timer. NO. 2 went with second choice run cap NO. 3 went with my thought, ( PTC Starter ) why not, most exp part. Fixed the problem.
Was this helpful?
Thank you for voting!
Freezer & fridge warm / condenser coils iced over
  • Daniel from North Plains, OR
  • Easy
  • Less than 15 mins
  • Screw drivers
Problem not consistent. OK for 2-3 weeks, then freeze coils. Mark and observe the defrost timers manual rotating adjuster. Timer would stop mid cycle. One revolution equals 8 hours of compressor run time followed by 30 minutes of defrost. Replacing timer took 5 minutes.
Was this helpful?
Thank you for voting!
compressor not running
  • wilson from indialantic, FL
  • Really Easy
  • Less than 15 mins
  • Nutdriver, Wrench (Adjustable)
thanks to all of the people who had the same problems I was able to make a quick fix on my fridge. I pulled the back cover off and found the compressor not kicking on so I replaced the start cap. and im back in bussiness.
Was this helpful?
Thank you for voting!
freezer frosted up and air could not circulate to the food section, causing the temperature to get warm, 55 degrees
  • PAUL from WEIRTON, WV
  • Really Easy
  • Less than 15 mins
  • Nutdriver
I followed the procedure online and found the thermostat was ok, it had continuity when cold, and the heater coil was also ok, it too had continuity, therefore the problem was a bad defrost timer. the refrigerator works great, thanks parts select!
Was this helpful?
Thank you for voting!
Freezer was cold bit the refrigerator was warm.
  • Christopher from Wilmington, DE
  • Easy
  • Less than 15 mins
  • Nutdriver, Screw drivers
Based on the diagnosis on this site I thought the 66% odds of the problem being the Defrost Timer looked pretty good, $30 including shipping versus a Sears tech phone estimate of $250-300. BINGO! Just follow the online installation instructions and don't forget to use the reset switch as described. Works like new! THANK YOU
Was this helpful?
Thank you for voting!
Freezer worked, Frig would not cool.
  • Dean from Sunset, SC
  • Really Easy
  • Less than 15 mins
  • Nutdriver, Screw drivers
Unplugged the frig. Removed temp control module from frig, 1 screw with nut driver. Activated defrost timer by rotating adjustment until 2 clicks are heard. Removed two timer mounting screws, unpluged timer, plugged in the new timer, mounted it to the control module with 2 mounting screws. Replaced control module with the 1 mounting sc rew. Closed door and plugged it up.
Was this helpful?
Thank you for voting!
Not defrosting and then warm up do to ice
  • Bryan from Red Oak, IA
  • Really Easy
  • Less than 15 mins
  • Screw drivers
replaced the defrosting timer and saved a lot of $ by doing it my self.
Was this helpful?
Thank you for voting!
Freezer and main compartment had wide temperature variations
  • Joseph from Tullahoma, TN
  • Really Easy
  • Less than 15 mins
  • Screw drivers
I first thought the defroster heater broke - took the back wall of the freezer off and cooling fins were fine. Then took the defroster timer out and opened it up. The contacts were badly burnt so the compressor and fan ran during only part of the cooling cycle. Replacing the timer took less than 5 minutes - turn off the power, remove o ne screw to take out the control box, cut the ground wire (new timer housing is plastic and does not have a ground connection), remove two screws to unmount the timer, unplug the old timer, plug in the new timer, fasten with two screws, put the control unit in and fasten with one screw, turn power back on.
Was this helpful?
Thank you for voting!
Refrigerator Ran Constantly, Was not Cooling as well.
  • Mark from Hertford, NC
  • Really Easy
  • Less than 15 mins
  • Nutdriver, Screw drivers
Looked up troubleshooting info on your web site. Decided to replace the defrost timer. Ordered it using Paypal. Received the Shipment in about 1.5 days in Rural NC. Watched Your Video, cut off power to the fridge, removed the top self and unbolted the panel, removed the defective defrost timer, installed the new one and re-installed the panel and top shelf. Set the timer to defrost to check the operation (looked inside the freezer to see that the defroster was glowing red - it was) waited about twenty minutes to ensure that the fridge started cooling again. Fixed!
Was this helpful?
Thank you for voting!
at first auto defrost would not work so I had to take the frezer panel apart and defrost it with a hair dryer every ten days
  • thomas from Chepachet, RI
  • Really Easy
  • Less than 15 mins
  • Nutdriver, Screw drivers
pulled down the thermostat cover and unpluged the timer control and replaced it with the new part. total time to repair was about 15 min. there was a vidio on how to replace the new part that just informed me that I did it right!!!!very easy site to find what you are looking for!!!!
Was this helpful?
Thank you for voting!
fridge shut down stopped running
  • robert from Holbrook, NY
  • Really Easy
  • Less than 15 mins
  • Screw drivers, Socket set
simply watched videos provided…making it EXTREMELY simple..saved me hundreds by not having to throw it out!! running better than ever like as if it was brand new!!
Was this helpful?
Thank you for voting!
All Instructions for the RT216TLD0
106 - 120 of 214