EasyApplianceParts is now PartSelect! We've merged our sites to provide a better shopping experience for you.   Full Details
✖

Find Parts

Parts Departments

Top Model Types

Top Brands

Repair Help

Expert Repair Videos

Keep typing for more specific results...

RT215MCD1 Frigidaire Refrigerator - Instructions

All Instructions for the RT215MCD1
91 - 105 of 202

Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!

Search filter:
Clear Filter
Your search term must have 3 or more characters.
loud noise fan blade broke,off balance
0 of 1 people found this instruction helpful.
  • EDWIN from ELWOOD, IN
  • Really Easy
  • 15 - 30 mins
  • Nutdriver
take 1/4 hex screws out clean out dust ,remove old fan blade replace with new install bolts .
Was this helpful?
Thank you for voting!
coil Iceing up
0 of 2 people found this instruction helpful.
  • Thomas from Stuart, FL
  • Really Easy
  • 15 - 30 mins
  • Nutdriver, Screw drivers
took 4 screws out of the discharge vent on top of the refrigerator section and unpluged the wiring harness and put the section on the counter and unscrewed the timer and put the new one in and reinstalled the assembly and plugged the Jack and put the 4 screws back in, and rotated the timer and put it on defrost removed the back and check the heaters and drain .
Was this helpful?
Thank you for voting!
leaking water down into fridge
0 of 2 people found this instruction helpful.
  • Ronald from Defiance, OH
  • Really Easy
  • 15 - 30 mins
  • Nutdriver, Screw drivers
just like the video showed...it was excellent!!!
Was this helpful?
Thank you for voting!
Getting the light socket to snap back in properly
1 of 5 people found this instruction helpful.
  • Robert from HELENA, AL
  • A Bit Difficult
  • Less than 15 mins
  • Screw drivers
It snapped in place.
Was this helpful?
Thank you for voting!
frig side not cool/freezer coils not defrosting
  • daryl from n.las vegas, NV
  • Really Easy
  • Less than 15 mins
unplugged frig,removed bottom front cover and loosend 2 screws at bottom front left and slid defrost timer out from behind metal panel,unplugged the old and plugged in the new.frig works great.
Was this helpful?
Thank you for voting!
freezer was freezing and no refrigerator
  • Michael E from Uniontown, PA
  • Really Easy
  • Less than 15 mins
  • Nutdriver, Screw drivers
Followed instruction vedeo from partselect. THANKS!!!!!
Was this helpful?
Thank you for voting!
Freezer & fridge warm / condenser coils iced over
  • Daniel from North Plains, OR
  • Easy
  • Less than 15 mins
  • Screw drivers
Problem not consistent. OK for 2-3 weeks, then freeze coils. Mark and observe the defrost timers manual rotating adjuster. Timer would stop mid cycle. One revolution equals 8 hours of compressor run time followed by 30 minutes of defrost. Replacing timer took 5 minutes.
Was this helpful?
Thank you for voting!
Freezer was cold bit the refrigerator was warm.
  • Christopher from Wilmington, DE
  • Easy
  • Less than 15 mins
  • Nutdriver, Screw drivers
Based on the diagnosis on this site I thought the 66% odds of the problem being the Defrost Timer looked pretty good, $30 including shipping versus a Sears tech phone estimate of $250-300. BINGO! Just follow the online installation instructions and don't forget to use the reset switch as described. Works like new! THANK YOU
Was this helpful?
Thank you for voting!
freezer frosted up and air could not circulate to the food section, causing the temperature to get warm, 55 degrees
  • PAUL from WEIRTON, WV
  • Really Easy
  • Less than 15 mins
  • Nutdriver
I followed the procedure online and found the thermostat was ok, it had continuity when cold, and the heater coil was also ok, it too had continuity, therefore the problem was a bad defrost timer. the refrigerator works great, thanks parts select!
Was this helpful?
Thank you for voting!
End cap clips broke
  • Wylie from Houston, TX
  • Really Easy
  • Less than 15 mins
  • Pliers
You just slide off the broken part and replace it with a new part. I had to make a slight adjustment to the end of the shelf rail to allow the new piece to properly mate with the old shelf rail.
Was this helpful?
Thank you for voting!
Freezer worked, Frig would not cool.
  • Dean from Sunset, SC
  • Really Easy
  • Less than 15 mins
  • Nutdriver, Screw drivers
Unplugged the frig. Removed temp control module from frig, 1 screw with nut driver. Activated defrost timer by rotating adjustment until 2 clicks are heard. Removed two timer mounting screws, unpluged timer, plugged in the new timer, mounted it to the control module with 2 mounting screws. Replaced control module with the 1 mounting sc rew. Closed door and plugged it up.
Was this helpful?
Thank you for voting!
at first auto defrost would not work so I had to take the frezer panel apart and defrost it with a hair dryer every ten days
  • thomas from Chepachet, RI
  • Really Easy
  • Less than 15 mins
  • Nutdriver, Screw drivers
pulled down the thermostat cover and unpluged the timer control and replaced it with the new part. total time to repair was about 15 min. there was a vidio on how to replace the new part that just informed me that I did it right!!!!very easy site to find what you are looking for!!!!
Was this helpful?
Thank you for voting!
Not defrosting and then warm up do to ice
  • Bryan from Red Oak, IA
  • Really Easy
  • Less than 15 mins
  • Screw drivers
replaced the defrosting timer and saved a lot of $ by doing it my self.
Was this helpful?
Thank you for voting!
Refridgerator not geting cold.
  • VINCENT from DEPTFORD, NJ
  • Really Easy
  • Less than 15 mins
  • Nutdriver, Screw drivers
Just followed the online instruction video .It was very easy.
Was this helpful?
Thank you for voting!
freezer cold--frig was warm
  • Robert from Chicago, IL
  • Really Easy
  • Less than 15 mins
  • Screw drivers
You guys at Partselect are the best!!! Went to your site, typed in my appliance symptoms, and received possible fixes. Ordered the suggested parts (under $50) on a Sunday night and got em Tuesday am. Installed the easiest one first and Voila!!!! Frig is working great. Thanks Bob S
Was this helpful?
Thank you for voting!
All Instructions for the RT215MCD1
91 - 105 of 202