RLN385UL (P1143085NL) Caloric Range - Instructions
Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Purchased home but stove had no broiler pan.
16 of 33 people
found this instruction helpful.
-
Raymond from BLOOMINGTON, MN
- Very Easy
- Less than 15 mins
Purchased 2 piece broiler pan from this site
Was this helpful?
Thank you for voting!
top oven gasket replaced
2 of 2 people
found this instruction helpful.
-
dennis from WESTFORD, MA
- Really Easy
- 30 - 60 mins
shortened gasket for this oven. moved hook approx. 1 inch. used high temp adhesive. simple fix.
Was this helpful?
Thank you for voting!
broiler pan missing
1 of 2 people
found this instruction helpful.
-
RAYMOND from JACKSONVILLE, FL
- Really Easy
- Less than 15 mins
ordered new broiler pan
Was this helpful?
Thank you for voting!
oven door would not stay closed [Broken hinge]
1 of 2 people
found this instruction helpful.
-
Ronald from Avon Lake, OH
- Really Easy
- 15 - 30 mins
-
Screw drivers
Slid the oven door off the hinges. Removed the 4 srews in the old hinges. Pulled the old hinges out of the front of the oven cabnet. installed new door hinges in oven cabnet with the 4 mounting srews.slid oven door on new hinges.
Was this helpful?
Thank you for voting!
Screws on the door of the dishwasher were very loose.
1 of 6 people
found this instruction helpful.
-
Kathryn from Carol Stream, IL
- Really Easy
- Less than 15 mins
-
Screw drivers
Went to PartsSelect. Put in Dishwasher model number. Chose the screws for that model number. Ordered the screws. Can't get any easier than that!
Was this helpful?
Thank you for voting!
Replace top oven seal
-
Linda from Oxnard, CA
- Really Easy
- Less than 15 mins
This is a simple replacement. The hardest part was that I had to shorten the seal because it comes 15 to 17 inches. So it needed to be shortened to properly fit. I cut the seal to fit, then took the metal hook on the end and super glued it to the cut end. I put a weight on it to make sure
Was this helpful?
Thank you for voting!