- Home
- RB17HN-2AF
- Instructions
RB17HN-2AF (8C63A) Magic Chef Refrigerator - Instructions
Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!
Search filter:
Clear Filter
Your search term must have 3 or more characters.
evaporator fan was noisy
6 of 11 people
found this instruction helpful.
-
Dwayne from Gastonia, NC
- Easy
- 15 - 30 mins
-
Nutdriver
First I unplugged the refrigerator. Next item was the ice-maker; remove (3) screws and unplug it from the back wall. Third task is remove the (4) screws that attach the back wall of the freezer compartment. Lift the wall up enough to dislodge the center cooling shaft that the fan rides in and remove the rear wall. The last item is the fa
... Read more
n motor which is attached to the freezer wall by (2) screws and (3) wires which are easily removed. Change out the motor and reassemble freezer compartment .
Read less
Was this helpful?
Thank you for voting!
motor wore out making loud noise
5 of 14 people
found this instruction helpful.
-
James from Bel Air, MD
- Easy
- 30 - 60 mins
-
Nutdriver, Pliers, Screw drivers
unplug the refrigator, remove everything from
frezer compartment. remove ice maker three screws and un plug. remove rear panel 4 screws
remove motor bracket from rear panel 4 screws
unplug motor . replace motor and reasemble in
reverse order. the new motor is very quiet.
frezer compartment. remove ice maker three screws and un plug. remove rear panel 4 screws
remove motor bracket from rear panel 4 screws
unplug motor . replace motor and reasemble in
reverse order. the new motor is very quiet.
Was this helpful?
Thank you for voting!
Temp in the refrig side was too high. Freezer OK
-
James from Sacramento, CA
- Easy
- Less than 15 mins
-
Screw drivers
I unpluged the refrig, removed the shelves and the back panel on the freezer side of the unit. This exposed the fan motor and fan blade. I removed two screws holding the fan unit in place, unpluged the wires connecting the fan unit to power, and then removed two other screws securing the fan motor to the bracket. I removed the fan mot
... Read more
or blade from the old unit and installed it on the new fam motor. I replaced the fan unit into the bracket, pluged the wires back into the fan motor and secured the motor to the refrig. Replaced the back panel and shelves, pluged the refrig into the wall.....easy.
Read less
Was this helpful?
Thank you for voting!