PVM1870SM3SS General Electric Microwave - Parts

This ceramic microwave fuse is just over an inch in length. It is white in the center, and metal on both ends. This is a 20-amp fuse, and is used to power your microwave. If the touch pad on the microwave becomes unresponsive, the microwave produces little to no heat, or the appliance simply does not turn on, it could mean that your fuse ...Read moreis at fault and needs to be replaced. Because this part contains an electrical charge, remember to disconnect power to the microwave unit before you begin this repair. NOTE: Before you start this repair, ensure that the microwave is unplugged, and the capacitor is discharged. A capacitor stores large amounts of electricity even after your microwave is unplugged.

This halogen light bulb is an inch and a half long. Carrying 120 volts and 20 watts, it is used with some microwave ovens.

The secondary door switch is a simple on/off mechanism that stops the microwave from operating when the door is open (normally opened). The switch monitors the door latch position, and communicates whether the door is open or closed to the electrical control board. This door switch is approximately 1 inch long, and has 2 metal prongs cal...Read moreled terminals that extend out of its body. Common symptoms related to a faulty secondary door switch include: microwave will not turn/shut off, or the microwave will not heat properly. NOTE: Before you begin this repair, first make sure your microwave is unplugged, and that your capacitor is discharged. A capacitor stores large amounts of electricity even when your microwave is unplugged.

The microwave glass light lens protects the light bulb inside the appliance. It is clear in color and measures approximately 6-1/2 inches long, and 2-1/2 inches wide. You may notice that this part is cracked or broken and will need to be replaced. You will need to remove the screw holding the cover in place. Unhook the cover from the bott...Read moreom panel. Bend the tabs up that are securing the old lens in place. The textured side should be facing up. Place the new lens into place and secure back into place.

This part accepts a D-shaped motor shaft.

This tray rotates in your microwave ensuring more even temperatures and is approx.14-1/2 inches in diameter.

This metallic vent hood filter collects grease particles in the air from cooking. Sold individually.

Unplug your microwave before attempting this repair. You will need to remove the grill, which is held into place by two screws at the top of the grill (open your microwave door before doing this). Remove the grill. Remove the screw on the left holding the control panel in place. Loosen the screw behind the panel. You should now be able to...Read more lift the panel up and pull forward to detach. You will find the door switch by removing the screws to detach the switch assembly. Press on the release tab to remove the middle switch. Disconnect the wire connector to release the old switch. The door switch is normally closed.

This stainless steel vent grille assembly is a precision-engineered component designed to mount above the microwave door, serving both functional and aesthetic purposes. It facilitates proper airflow by allowing heat and steam to escape from the microwave interior, helping to prevent overheating and maintain consistent performance. The gr...Read moreille also acts as a protective barrier for internal components, shielding them from external debris while contributing to the appliance’s sleek appearance. Constructed from durable stainless steel, it offers long-lasting reliability and resistance to heat and corrosion. Installation is straightforward and typically involves removing the existing grille and securing the new one in place with screws. For safety, power should be disconnected before beginning the replacement process.

Sold individually.

This part allows power to go one way only.