PSA9120SP1SS General Electric Microwave - Parts

This light bulb is located on the inside of your microwave. The bulb is behind the top grill. It will need to be replaced when it has burnt out and no longer works. Unplug the unit before beginning this repair. Remove the top grill of your microwave, use your screwdriver to open the light socket, scrape off any silicone holding the bulb i...Read moren place, clean the area of any oil and dirt, insert the new bulb into the socket without touching the bulb, slide the holder back into place, line up the tabs on top of the metal plate, and secure the holder back into place.

This ceramic microwave fuse is just over an inch in length. It is white in the center, and metal on both ends. This is a 20-amp fuse, and is used to power your microwave. If the touch pad on the microwave becomes unresponsive, the microwave produces little to no heat, or the appliance simply does not turn on, it could mean that your fuse ...Read moreis at fault and needs to be replaced. Because this part contains an electrical charge, remember to disconnect power to the microwave unit before you begin this repair. NOTE: Before you start this repair, ensure that the microwave is unplugged, and the capacitor is discharged. A capacitor stores large amounts of electricity even after your microwave is unplugged.

This is a grease filter compatible with various microwaves. Grease filters are used to collect food grease and prevent buildups on the internal components of the microwave, such as the fans and other electronics. This grease filter is made of mesh and measures 7.5 inches long by 5 inches wide. If your current microwave grease filter is cl...Read moreogged with grease and not able to be easily cleaned, it should be replaced. This filter can be replaced easily by pulling on its D-clasp and pushing the new filter into place. Depending on how many filters your microwave uses, you may want to consider how many you need before ordering. This filter is an OEM part and is sold individually.

Restore light inside the cooking area or over the cooktop with this replacement halogen lamp, it fits select microwaves, wall ovens, ranges, and microwave oven combos, disconnect the power before starting the repair, use the exact model number to confirm fit.

This interlock switch is located in the door latch.

This is the replacement damper bracket for your microwave. It is made of plastic and is approximately 11 inches wide and 3 inches long. The damper bracket attaches to the outer cabinet and directs airflow through the vent duct. The main reason you would replace the damper bracket is if it is damaged and will not hold the damper in place p...Read moreroperly. This part is sold individually and is a genuine OEM part sourced directly from the manufacturer.

This mounting plate, also known as a bracket, is crucial for keeping your microwave mounted to the wall, when placed above the stove. This OEM part is sold separately from the screws that are needed to hold it in place. You will need a screwdriver in order to secure the mounting bracket into place. Part has been substituted. Part is no lo...Read morenger a U-shaped bracket, it is now a flat mounting plate and will function the same.

This part is the replacement high-voltage diode for your microwave. It is approximately 3 inches long and is sold individually. The high voltage diode is an electrical current control device inside your microwave. Be sure to disconnect power to the microwave, and use extreme caution when completing this repair, as microwaves can still ret...Read moreain an electrical charge even when unplugged. This part is an authentic OEM part sourced directly from the manufacturer.

This switch monitor interlock is a critical safety component designed to ensure proper communication between the microwave door latch and the control board. When functioning correctly, it confirms that the door is securely closed before allowing the microwave to operate. A damaged or faulty switch may prevent the unit from starting, even ...Read moreif the door appears latched. Replacing this genuine part restores safe and reliable operation. Installation should be performed with care, and it's recommended to disconnect power before beginning any repair.