PCE6435 (Type 1) Porter Cable Trimmer - Parts

This Ball Bearing is sealed on both sides. It is a genuine DeWalt replacement part and is sold individually. • Ball bearings are used to reduce friction between rotating parts.. The balls or rollers take the load and spin, distributing the weight evenly while the minimal contact area of the ball reduces friction. This reduces wear on ...Read morethe tool and allows it to run smoothly. • Bearings experience constant wear when the tool is in operation from pressure, heat, vibration and friction. Because of this, many Bearings need periodic maintenance or replacement.

This part is available as an individual replacement. The sub-base is made of plastic and attaches to the base. When replacing this part a screwdriver may be needed. It will require replacing if it becomes cracked or broken. This item is an original part from DeWALT for use in laminate trimmers.

This is an authentic DeWALT replacement part, sourced directly from the manufacturer. The collet is found in a laminate trimmer, and is used to clamp the bit in place. This is a metal part, and is sold individually. To replace this part, you will need a wrench to loosen the collet nut, and then the collet should be simply to remove. You may also need a screwdriver to reach the part for replacement.

This is an authentic DeWalt replacement part that has been sourced from the original manufacturer to be used laminate trimmers. The brushes fit into the motor housing. The brushes are used to relay electricity from the switch to the motor's armature assembly. The brushes are sold as a pair.