PB-300E Echo Leaf Blower / Vacuum - Overview

This OEM Fuel Filter is a silver and white, steel/felt, part measuring about 1.25 inches in length and 3/4 inch wide. It can be installed with pliers and is rated as Easy to install by customers. This part attaches inside the fuel tank to clean the fuel of debris, and should be replaced during regular maintenance, check your manual for ...Read morerecommended replacement time. If the filter is leaking or it has a blockage preventing fuel flow, then it should be replaced. If the engine sounds like it is not getting enough fuel, then remove the filter and check it for blockage.

This is an authentic Echo replacement part designed for use with backpack blowers. This part interlocks with the other blower tubes that are sold separately. Over time this part can crack allowing for air leaks. This will greatly decrease blowing/suction ability of the unit, at this point part should be replaced. This tube is made out of black plastic and it is sold individually.

This manufacturer approved replacement part is used on Echo backpack blowers. This part interlocks with the other blower tubes that are sold separately. Over time it can crack allowing for air leaks. This will greatly decrease blowing/suction ability of the unit, therefore this part should be replaced. This tube is made out of black plastic and it is sold individually

This spark plug wire, also known as a spark plug coil or spark plug cap coil, is compatible with various makes and models of hand-held outdoor power equipment and is sold individually. This wire is installed within the spark plug boot and attaches to the spark plug for the ignition of your equipment. The spark plug wire is often exposed t...Read moreo extreme heat and excessive vibrations, so through normal wear and tear, it will likely break down. If your equipment is having difficulty starting or has general performance issues, the wire may be the reason why. To replace this wire, make sure your equipment is off before removing the wire and boot from the spark plug. Remove the boot from the wire and install the new wire within the boot before re-installing the boot back to the spark plug.

This is an authentic manufacturer sourced replacement part designed for use with Echo backpack blowers. This carburetor gasket provides an air tight seal between the carburetor and the insulator. Over time gaskets tend to deteriorate and would need to be replaced. It is made out of compound material and it is sold individually. You would need a screwdriver to replace this item.

This replacement screw is specially designed for use with Echo handheld lawn and garden equipment. It is a high quality OEM sourced item, not an aftermarket imitation. This screw is a standard hardware which has multiple uses depending on the equipment. Please note, this hex socket head screw is sold individually.

This replacement part is an authentic OEM screw designed for use with blowers and string trimmers. This is a standard hardware which has multiple uses based on equipment. Please refer to diagrams for proper application. This screw is made out of metal and it is sold individually. To secure or loosen this screw you would need a phillips head screwdriver.

This is an original part from Echo. The metal rewind spring is made for use with a variety of lawn and garden engines. This item is fitted between the recoil drum and the starter plate in the starter assembly. This component rewinds the starter rope after has been pulled to start the motor. A screwdriver is required for the repair. The rewind spring is sold individually.

This is a simple adhesive sticker/decal with Echo logo. It is commonly used on handheld lawn and garden equipment such as trimmers and blowers. Please make sure to check appropriate diagrams of your model to check the location for this label. It is an authentic manufacturer approved replacement item which is sold individually.

This is an authentic OEM supplied replacement starter rope that is produced for use with Echo gas powered equipment. It is the part of the recoil starter mechanism which allows user to pull-start the engine. One durable nylon rope is included per order, please note the plastic grip handle is sold separately.

Made specifically for repairs done on handheld lawn and garden equipment, this OEM wrench is silver and made of durable metal. It is sold individually. This wrench is sourced directly from the manufacturer and should be replaced once it becomes damaged or worn.