This light lens cover is supplied by the original manufacturer for use with range hoods. It is a plastic rectangular cover measuring approximately 5.25 inches by 4 inches that protects the light bulb within the range hood. The cover shields the light from moisture, grease, steam, and other emissions that could affect the light bulb functi...Read moreonality. Over time, the plastic material may crack, warp, or become discolored, affecting the ability of the light to pass through the cover. Remove the screws that attach the old light cover to the range and pull it off. Position the new cover on top of the light bulb and reinstall the screws.
A black rocker switch gives the user simple on-and-off control from the appliance panel. Depending on the appliance, it may operate an oven light or an exhaust fan. Pressing either side of the switch opens or closes the electrical circuit. Replacement may be needed if the switch sticks, feels loose, or no longer turns the connected featur...Read moree on. Shut off electrical power at the breaker or unplug the appliance before beginning the repair. Wear work gloves and label each wire before disconnecting the old switch.
See how others fixed this model. Time, tools, difficulty, and steps that lead to victory!View More
Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!
Search filter:
Clear Filter
Your search term must have 3 or more characters.
The switch on the exhaust fan for the grill part of the stove went bad. I found the part on your site easily , ordered it and got it within 4 days.
13 of 22 peoplefound this instruction helpful.
Al from Abbeville, AL
Really Easy
Less than 15 mins
Pliers, Screw drivers
I simply looked at the new switch , to see how it fastened in the stove. It had plastic clips that were easily depressed to allow the swithch to be removed. I removed it , (after turning the circuit breaker off to the stove) removed the three wires , and replace them on the new switch and simply pushed it in the space. It snapped in place
... Read more , and the job was done . Works great!
Read less
Was this helpful?
Thank you for voting!
Removing the old fan rocker switch on our Jenn Air gas range and replacing it with the new one
3 of 4 peoplefound this instruction helpful.
Donald from OURAY, CO
Really Easy
Less than 15 mins
Pliers
It is really easy to replace IF you know that the tabs that hold the switch in are ON THE TOP AND NOT ON THE SIDES. I wasted a lot of time prying on the sides to get the switch out. It would have been really easy if I had known the tabs were on the top and bottom.