NVL333EB4WW Hotpoint Dryer - Parts

This part is used to start the dryer once you have selected a setting on the timer.

The lower front felt seal with adhesive, also known as a drum felt seal, is used in dyers and allows the drum to easily glide on the front panel. For this repair project, you will need the following tools: #2 Phillips screw driver, #2 square head screw driver, putty knife, and wire bush. If your dryer will not tumble, or makes a squeaking...Read more noise when running, replacing this part could solve the problem. Remember to unplug your appliance from the power source for safety before you begin this installation project. Refer to the manual provided by the manufacturer for further installation instructions.

Used to turn the drum.

Bearing Only. This part helps your appliance run as quietly as possible.

This kit comes with the rear bearing, shaft support, lubricant and other items required for the installation.

Sold individually. There are some dryers that require 2 per dryer. They attach to the outer-most sides of the bearing.

This bracket is used on the drum bearing.

Screws are not included. Handle only.

This hi-limit thermostat acts as a safety mechanism that keeps the dryer from overheating. With this thermostat, a dryer's heating element will cut out if the internal temperature reaches 260 degrees Fahrenheit. The element will kick back in when the temperature drops to 190 degrees Fahrenheit - the differential of 70 degrees.

This thermostat controls the internal drying temperature. Cycling themostats continually cycle the heating element off and on to maintain a constant inner temperature. This particular cycling thermostat has a limit of 140 degrees Fahrenheit and a differential of 10 degrees. Meaning that with this thermostat, the heating element will cut ...Read moreout at 140 degrees and cycle back on once the internal temperature drops by 10 degrees.