MWS445RES2 Frigidaire Washer - Parts

The capacitor is used on the washer motor to help the motor get up to speed quickly before transferring power to the run capacitor.

This is the bolt (screw) that holds the agitator in place.

This water inlet hose is used in washers. The hose connects the washer water inlet valve to the water supply in your home. There are two solenoids on the valve, which are referred to as coils, and there are two wires attached to each solenoid that should be labelled to ensure they are properly reconnected after replacing the new hose. Ove...Read morer time, your hose can begin to leak which can lead to floods. Replacing your hose earlier on can prevent this problem. Refer to the diagram provided by the manufacturer for installation instructions. Remember to unplug your appliance from the power source before beginning this installation project.

Use in conjunction with the agitator screw.

This clip is less than an inch long.

This part helps with the spinning and agitating cycles.

Appliance requires 2. Sold Individually. They are located on top of the service panel to be able to attach it to the main frame of the washer.

Sold individually.

The timer controls most of the operations of the washer: water level, tub filling and emptying, length of cycles, and cycle setting sequences.

This basket drive tube seal or upper lip seal is used for a top washer and is located on top of the transmission, below the agitator drive block. The tube seal functions as a protective tool to prevent water from leaking into the drive tube. The measurements for this seal are: 4 inches in length, 1 inch in height, and 0.01 lbs in weight. ...Read moreRemember to unplug your washer from the power source before beginning this installation, as a safety precaution. For installation instructions and accurate guidance, refer to the manual provided by the manufacturer.