MW8900XS6 Whirlpool Microwave - Instructions

Ordered a new door frame morning of March 25.
Part arrived the next morning and by that afternoon, the
replacement was complete. Only four screws held the frame.

The microwave is the upper unit of combination microwave & conventional oven. Disconnect power to the unit. Slide unit out of built-in cabinet to expose the top shield of the microwave. Remove 5 screws holding top cover in place. Remove cover, which exposes the belt reel and drive motor. Install the new belt by threading it on the dr ... Read more ive motor pulley, then walk the new belt on the stirrer pulley. Replace the top cover and reinstall the 5 screws. Reinstall the combination unit in the wall cabinet. Reconnect electrical power. Task Complete. The belt just seem to die of old age about every seven year. Without the wave disperser operating, the microwave oven does not give even heating.

Just pulled the old support out with pliers and installed the new one which snaps in. Not sure why the support melted as it has been the same one twice now. Keep extra support clips on hand, but no need as Parts Select had the new ones here next day.

This microwave is the upper unit in combination with an oven. Microwave portion is Model RM288PXS. Cut power at breaker box. Remove metal frame around 2 sides and top, (5 screws). Remove 4 screws on bottom, whicn anchors the unit to the frame.Remove contol panel (2 screws at top) and swing down. Pull out female electrical socket at ... Read more bottom right back in conrol unit space. Now pull out microwave from frame about 6-8 inches. This provides access to pulleys on the motor and wave disperser. Put on belt. Reverse the above procedure to finalize the repair. This is the 3rd time I have had to replace this belt. They last about 6-7 years. Without the wave disperser , the microwave does not provide even heat.

Just pushed in a new clip which was very easy.
Excellent service. Only took 3 days from Calf.

dismantled the door to be sure handle would fit. Had to drill extra holes to re-enforce broken frame parts to metal door components then re-assemble. Parts were very fragile and subject to twisting out of square upon reassmbly. New handle is solid and door closes securely,microwave works fine.

Removed 5 screws on microwave trim and three additional screws on cabinet. Pulled microware part way out to expose broken drive belt on top and replaced with new one. Note: Microwave cabinet caught on connector in back of chasse and pulled it loose. Moderate difficulty in reaching back and reconnecting it. Otherwise an easy job that saved ... Read more $125 on service call and part was half the cost.

Removed splash Guard to replace light bulb, reinstalled splash Guard. Installed new support clip.

This is a 1988 vintage microwave oven. I'm very relieved to have parts still available. The stirrer drive belt tore. I suspect dry rot, as I did this exact repair back in 2005.You simply remove the cover, replace the belt [easy] on top, and replace the blown fuse. While the oven cover is off blow out all accumulated dust and wipe/clean al ... Read more l areas that have a build up of dirt/crud. I purchased this microwave oven in 1988 and is very dependable.