MW81 Microwave - Instructions

The hardest part was taking out original light bulb because screws on shield where hard to unscrew after all this years . The old bulb vent out leaving neck in socket. It took narrow electrical pliers to get neck out .The generic appliance bulb did not fit and had aluminum neck ,not recommended for brass sockets in ovens.Putting new ligh ... Read more t bulb in was not the problem.

1. Unscrewed glass cover on bulb
2. Removed old bulb
3. Screwed in new bulb
4. Replaced glass cover
5. Mixed drink & baked cupcakes

very easy

Screwed in light bulb and glass protector

My husband took the plastic cover off and took out old bulb and screwed in the new one. Then put the cover back on.

I pulled down the wire around the glass cover. . . Released on end of the wire from its holder being careful to not let the glass cover drop. Unscrewed the bulb and replaced with replacement. Easy, easy.

My repair went terrible as I was sent the wrong motor 2 times. My stove sat in the middle of my small kitchen for 2 weeks. Finally the 3rd was the correct one except I didn't have the right nut so I waited another day for that to be sent. Everything working good now, I just hope the bottom fan doesn't go out after this experience.

dismantled the door to be sure handle would fit. Had to drill extra holes to re-enforce broken frame parts to metal door components then re-assemble. Parts were very fragile and subject to twisting out of square upon reassmbly. New handle is solid and door closes securely,microwave works fine.

Simple replace

First off if you are repairing an appliance this old better have some super glue. Many of these parts are no longer available. If the latch breaks with the door closed you can clear the broken plastic latch and open the door with a straightened coat hanger through the handle into a hole on the door which will trigger the latch. Once th ... Read more e door is open there are two screws that hold the black plastic trim piece on the inside of the door. Remove them both (Phillips head). The piece will come off. The handle is held to the front of the door by two more Phillips head screws. One at the top and one at the bottom. The handle in the front will not yet come off. There is one more screw that can only be reached by separating the door parts so you can get the screwdriver in. Now the whole handle will come off. Orient the new handle "trigger" so the piston can go through the hole in the handle. Be sure to put the spring on so it goes between the trigger and the handle. Now put the handle back on the door being sure to put the piston through the hole in the handle. It is best to put that screw in the middle back in place first then the others at the top and bottom. Put the plastic trim piece back on the inside and your are done. For what it is worth the trigger that I got is brown and not black like the other trim. Really not much of an issue.

Received the part the day after ordering. Appreciated the quick service and repair took less than a minute.

Removed 5 screws on microwave trim and three additional screws on cabinet. Pulled microware part way out to expose broken drive belt on top and replaced with new one. Note: Microwave cabinet caught on connector in back of chasse and pulled it loose. Moderate difficulty in reaching back and reconnecting it. Otherwise an easy job that saved ... Read more $125 on service call and part was half the cost.

Remove the housing cover which requires removing 7 screws that hold the cover on. The bulb and the pully's that the belt goes on are visible and the belt is easy to replace as is the bulb.

Pretty easy tear down and assembly once I removed it from cabinet (built in micro)